answersLogoWhite

0


Best Answer

When you make a left turn and push your clutch in it stays on the floor

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When do you know you have crankwalk on a 1997 eclipse turbo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a 2000 model eclipse engine work in a 1997 eclipse?

negative only 420a motor for non turbo or 4g63 for turbo model...or extensive modifying. i don't know why you would want to. 2000+ eclipse motors are garbage as well as the dodge 420a non turbo motor...the only motor that sould have ever been put in the eclipse is the 4g63 period.


How do you know if your vehicle is a Mitsubishi eclipse gt turbo or just a Mitsubishi eclipse gt?

there is no gt turbo. there was only the gs turbo and the gsx which was turboed, the gt didn't come til the 3rd generation eclipse which was in 2000 but 2000+ are all non-turboed.


Exactly where are the o2 sensors on a 1997 gst 20 turbo engine?

need to know the numbes of a transsmion that is used for a 1997 mitubishi 2.0 turbo.


How do you know if 1995 Mitsubishi Eclipse is turbo or non turbo?

look at the engine, is there a snail shell looking thing attached to the front of the engine...if so then u got one. ------ If your Eclipse is a GS or RS it did not come from the factory with a turbo. the engine should be on the passenger side of the car. That engine is a 420a. If you have an Eclipse GSX or GS-T then you have a turbo charged engine. the engine will be on the drivers side of the car. this is the 4g63 engine. it is possible to have a 420a with a turbo, but someone will have had to put it on themselves, and you would probably know that when you bought it.


What is the firing order on a 1995 Mitsubishi Eclipse turbo engine?

When diagnosing engine trouble it is important to know the firing order of the engine. The firing order of the 1995 Mitsubishi Eclipse is 1,3,4,2.


Where is the turn signal relay for a 1997 Volvo 850 sw turbo?

i dont know i came here for the answer


Where does the oil feed line attach to after being attached to the turbocharger itself this is going on a 99 Mitsubishi's eclipse rs and i need to know where that oil line attaches to.?

The oil line that feeds your turbo needs to come from the oil sending sensor on the driver's side back of the block. Check out this site... http://www.2gnt.com/index.php?d=GSGoinFast%20Turbosystem This page goes through the installation of a turbo system on a non turbo eclipse.


How do you know if your car is turbo?

Look on the exhaust system for the turbo unit.


How will you know if you have the turbo?

It is quiet obvious when you have a turbo because when you accelerate you hear a whistling sound. The turbo noise is unmistakable.


How do you know if your 1987 rx7 is turbo?

if you don't know this, you shouldn't drive an rx7...look at the engine...do you see a turbo???


Can you swap a 1990 eclipse GSX turbo motor to 1995 eclipse GSX?

Go to magnusmotorsports.com and look in their tech section. Click on the article 1g in a 2g. It covers the entire swap. If you have any questions you could call them or visit dsmtalk.com or dsmtuners.com www.DSMTalk.com ... Search there, you will find everything you need to know about your car.


What would cause a 95 turbo eclipse to jump time if you have already replaced the tentioner?

I don't know about a tentioner? Tensioner? But apparantly a flux capacitor can cause your vehicle to jump time. At least it worked on Emmit's Deloreon!