answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: When do you use bypass to pool on a sand filter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is it safe to use Dawn in your sand filter to clean the sand?

Sugest you use one of the cleaners that are made to do this job available from the pool shop.


Chemical to use to clean pool sand filter?

Sand filters are not cleaned with chemicals . they are back washed when required. every four or five years it pays to replace the sand in a sand filter to maintain its efficiency.


If you put a sand beach next to your in-ground gunite pool will the sand that ends up in the pool cause problems with the filter?

If you have a sand filter as your filter you may need to remove some of the sand from time to time, But most will be dunped during backwashing. If you have a cartridge filter you may have to clean it more often. If you use D.E. the sand will be dunped when you backwash,Other then that there is no harm. A: Why would you want to be tracking sand into your clean pool? You are just adding more contaminants. YUK !


Why is soap scum coming into pool through sand filter since treating pool for black algae?

dont use soap use clorine


What setting should you have your pool on for normal operation?

If you're talking about your pool filter, it should be set to filter or run. Use the bypass or recirculate setting if you wish to circulate the water without having the water pass through the filter. Use the backwash setting to clean the filter.


Can you use play sand for a pool filter?

No, it'll blow right back to the pool which will then make it hard to remove. Sand filters REQUIRE a #20 grid pool filter sand. There is also another product possible called zeolite for sand filters... it will filter finer than sand.


How do you find out what size sand filter you have?

Usually the top of the sand filter is above the water level of the pool, so all you have to do is unscrew the top and look in. However if the filter is below the pools water level you will have to cut of the water coming from and to the pool before you do. who added the sand? If you did - did you follow the manufacturer's instructions as to how much and what type of sand to use? Instructions tell you - - SPECIFICALLY - - how many pounds of # 20 silica sand to use.


When opening a pool what chemicals do you use and how do you get a sand filter up and running?

Pray for a salt water system


What grade of sand to use for pool filter?

.017 to .022 silca sand found at any pool supply store New: I doubt that you are going to find .017 or .022 sand even at a building supply place that specializes in sand, plaster, rocks, gravel etc. A #20 silica sand is what is available for swimming pool filters and that is what should be used. .017 sand may in fact be too small for the latterals in a sand filter thus letting small amounts of sand to pass thru to the pool daily resulting in a buildup of dust and sand on the floor of your pool.


How do you chlorinate your pool with a sand filter?

Yes, if the sand in the "sand filter" is dirty. Clean water from the pool passes over the dirty sand bed in the filter thus reducing the amount of chlorine in the water. If it is sand from the beach or surrounding landscape - the answer is also yes because it is adding contaminants to the pool water. Anything that comes in contact with the water reduces sanitizer levels including the sun, wind, humans, pets, ducks, dust, pollen, cosmetics, under arm deodorants and on and on. Ken


How do you get rid of dirt in a swimming pool without a vacuum?

This sounds as thought the laterals in your sand filter are worn. Laterals are horizontal spokes at the bottom of your sand filter with tiny holes in them that let water through but not sand. After a time the holes get enlarged and start allowing sand through and back into the pool


Above ground pool filter sand?

You might have too much sand in the filter. I use a diatomaceous earth. When I used too much there was leakage back through the strainer.also I found my pipe cracked inside my filter bowl and sand was seeping into the pool, removed all sand and did some home pluming replacement.very simple job to do...