0
When my Mazda 93 B2200 pick up truck only turns over and does not start what could the problem be?
Wiki User
∙ 13y ago
First question is the truck getting fuel and spark.If you smell fuel and it is just flooding it would point to the electrical side of the system.I would recommend checking for spark by removing the number 1 spark plug wire(have someone turn the truck over,while you have the plug boot to the plug remove but very close to the plug) it should show a spark.If you have no spark it could be several things.It can be either bad wires,bad distributor cap and rotor button or even a bad coil.I would just do a tune up FIRST being new plugs,spark plug wires,distributor cap and rotor button.If after this the truck still does not start it will only point to TWO items either the coil is bad,or the ignition pick up inside the distributor is worn.If the problem is not the electrical side being the items above and it is not getting fuel,it could be a clogged or dirty fuel filter or a bad fuel pump which on your model will be inside the FUEL TANK.If the fuel pump is not working at the prescribed psi (meaning too low) the truck will not start or even try to start due to lack of fuel.Unless I missed the question totally please reply back on this post specifically under the discussion which is highlighted and add information relevant to the issue.Hope this helps.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
1987 Mazda B2200 The motor runs grea just had the top end rebuilt Now when you start the motor and then put it in gear the motor dies you were told it could be a control module Any ideas?
if this is a automatic truck change the distributor pick up had same problem on 1989 b 2200
90 Mazda b2200 fuel injected wont start has fuel spark and timing what's Wrong?
I have the same problem, I have seen somewhere that it might be the ECM (Engine Controle Module), if you figured the problem out please help, I will keep trying and looking on my side and will post any news.
Your 94 Mazda protege wont start it cranks over but doesn't start?
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
Have 93 Mazda B2200 and need to know what the name of the switch is that is activated by depressing the clutch pedal so the truck will start?
This is usually known as a neutral safety switch or shift interlock switch.
Why dos the fuel gauge on a Mazda b2200 truck not get any power and the fuse is good?
Check the fuel control relay behind the drivers side kick panel. Could be bad. If that is ok start at the fuel tank and check the wires and connectors to the front of the truck. Good Luck Jerry
Why does your Mazda 626 not start when it still has spark?
could be fuel starvation
How do you get a key out of an ignition of a 1993 Mazda protege it is stuck and you cant even start it or remove the key?
i have no clue i have the same problem with my Mazda 1999 626
Your 2000 Mazda 626 was left out from october til January now it wont start What is the problem?
Battery dead.
I have a Mazda 1989 626 and it wont start all the time The time it doesn't start it will just click Ive replaced the starter battery cables neutral safety switch and the battery?
I have a 89 Mazda 626 with a similar problem. Sometimes when I go to start it it won't start. (It does not click like yours does.) All I do is put the car in neutral and turn the key. It starts right up. Maybe this could help you.
The engine turn over but wont start what could be the problem?
I do not have a answer for it, do you an answer for this problem?
What is the problem of nissan elgrand it does not start while switch on is ok?
The problem with the Nissan Elgrand if it does not start when the switch is on could be a mechanical problem.
When you try to start your Mazda mpv v6 2wd it beeps but will not start what is the problem?
engine ecm 10 amp fuse in the lower kick panel blown
