C401 c402
strobe is enable input in a digital IC...if its made active high...it will be enabled..some IC strobe is active low.. Its function is to enable the operation of the IC..or gate or Mux...
Two methods, one uses a dial that is held in the center of the revolving shaft and is directly read off of the dial face. The second method uses a strobe light. The light is focused on the shaft and the dial on the strobe is turned until it looks like the shaft has come to a stand still. The RPM is read off of the meter face of the strobe light.
Program Store Enable: The read strobe to external program memory.
The strobe pin on the LM311 is used to disable the output, so that multiple 311's can be ganged together, with only one being turned on at a time. It is also used to adjust the balance of the device.
Assuming there is one reference mark on the rotating object to start with, a strobe tuned to exactly one half times RPM will show only one reference mark, i.e. one every other revolution.
There are a lot of places that you can purchase a strobe phone from. One place that you can get the strobe phones is from www.kyocera-wireless.com/strobe-phone/
The anagram of 'strobe' is sorbet.
Strobe lamps use xenon.
Answer=1.A Strobe is a light that flashes on and off continuously.
A strobe light is typically a halogen bright white light with a timer on it that turns on and off the pulse of the light to create a strobe effect on it.
CAS ( Coloumn Access Strobe) RAS ( ROW Access Strobe)
Whelen Strobe is a brand of lights, specializing in strobe light technology. The company, Whelen Engineering Company Inc., was established in 1952 in New Hampshire.
Strobe Talbott's birth name is Nelson Strobridge Talbott III.
Strobe Talbott was born on April 25, 1946, in Dayton, Ohio, USA.
xenon
strobe is enable input in a digital IC...if its made active high...it will be enabled..some IC strobe is active low.. Its function is to enable the operation of the IC..or gate or Mux...
It is a data selector. There are 16 digital input lines, 4-bit decoder, strobe and output pin. So you put a 4-bit binary number from 0-15 into ABCD bits and the corresponding input value is found on output at the strobe time.