To change the bumper (a mechanical device consisting of bars at either end of a vehicle to absorb shock and prevent serious damage)is about 1 hour but...
have you Plastic/Metalic screw....fixed clamps...the right Tool..??? That's why I give the link : http://www.tkqlhce.com/n6122cy63y5LONNTSUVLNMPSNRQR for the Manual + Tools + Technique and even the Bumper
Regards ChrisA.
webmaster@productselected.com
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
The front bumper on a 1991 Acura Integra is held on by several mounting screws. Remove all the screws and gently pull the bumper off the remaining mounting clips.
remove the side markers and then the screws under them, also screws under latch cover in trunk, underside of bumper, behind fender liners.
easy remove 4 screws securing top of grill. remove 2 screws holding inner wheelarch to bumper. bumper cannow be unclipped. remove 3 screws holding headlamp jiggle lamp free enough to gain access to bulbs 2012 corsa
You can remove the sun visor on your Toyota Rav4 by removing the screws on the swivel arm. When they screws are remove the visor should come off.
First, remove the nut from the middle of the bumper, and then remove the nut from the the mounts at each rail frame. Then remove the nut or screw holding the bumper to the car at the area of the wheel. Remove the old bumper, put on the new bumper, and replace the screws in nuts in the reverse order.Ê
The rear bumper on a Honda Civic is held on using several mounting screws. After remove each screw the bumper will be held on with mounting clips. The bumper can be gently pulled off.
first remove the bumper turn lights...two screws on one each light..then remove the lights carefully, so you do not break them.... After that...remove the bumper screws in the wheel wells.... Then, where you have removed the bumper lights...with a socket extension..and a 12 mm socket...remove two bolts on each bumper mounts.....then the bumper should come off in a forward direction.... you now have access to both headlight assemblys.
remove the screws and pull it hard
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
you have to remove the screws from the top of your bumper and remove the screws from the front of the wheel well bumper should slide forward then remove two bolts on top of headlight then remove bolt under headlight then housing should come right out