answersLogoWhite

0


Best Answer

All you need to do is erase the trouble code associated with the crankshaft positioning sensor. You will need a code reader to do this.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When replacing the crankshaft position sensor on a 2001 Pontiac Montana 3.4 is there a need to take it to a dealer for a Learning period?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the location of the crankshaft position sensor on a Pontiac Montana?

Pending on the year and engine size, some are located within the area of the harmonic balancer.


When replacing the crankshaft position sensor on a 2001 Pontiac Montana 3.4 is there a need to take it to a dealer for a learning procedure?

No you should be fine if you didn't unhook the battery for a long period of time. The OBD 2 ECM is alot better and smarter then the older OBD 1 ECM. If the Check Engine light still stays on then you will need it tested and cleared. Unhooking the battery will not clear any codes. The learning process is done after 10 miles or so. If it starts and runs fine then your ok but if the alarm and keyless entry does not work if equiped then you will need to take it to the dealer to be reprogramed.


Where is the location of the crankshaft sensor on a Pontiac Montana transport van?

That is closer to the time belt u have to remove the belt firts


How do you replace a throttle position sensor on a 2000 Pontiac Montana?

The throttle position sensor can be removed by dismantling the chassis in which it sits. This can be done by referencing the owner's manual f the Pontiac Montana.


Cost of replacing water pump on Pontiac Montana?

It will run you $30-40 depending on part store.


Where is the throttle position sensor on 1999 Pontiac Montana?

The throttle position sensor is located on the throttle body at the end of the throttle shaft.


Why does your Pontiac Montana sv6 has a rough idle?

yes mine had a really rough idle and it turns out the motor mount needed replacing


What is the average cost of replacing intake manifold gasket on a 2003 Pontiac Montana 3.4?

parts and labor should run around $650


Changing 2002 Pontiac Montana radio bulb?

by replacing the radio unless you are inclined towards successful and attractive African American re-engineering.


How do you you reset the wiper motor on a 2002 Montana the wipers stay in the upright position when shut off?

It is definitely a pin inside the wiper motor that is worn out. I just had mine replaced in my 02 Montana. The pin can be seen by removing the cover from the motor.


What would cause spitsputterbackfire and stall out on occasion on 1997 Pontiac Montana Please help?

Sounds like a timing issue. There is no way to advance or retard the timing in the newer models unfornately. Either the distributor\coil pack is going bad or you are getting bad sensor readings from a sensor, possibly the crankshaft position sensor. Is your MIL comming on? If it is then get the code read and start from there. Autozone will read then for free. I hope this helps you some.


Is Selena Gomez seriously replacing Miley Cyrus on Hannah Montana?

No, she isn't, Miley Cyrus is staying on Hannah Montana. Besides, Selena Gomez is already stars on a Disney Channel hit television show, Wizards of Waverly Place. It is said that they might replace Miley with Selena, or they may get someone that is unfamous to play Miley Stewart/Hannah Montana, but this is more than likely untrue information.