95 Chevy impala egr valve removal
Where is the EGR unit located on a 2001 Chevy Impala? picture please
The AC recharge valve on a 2001 Chevy Impala 3.4L V6 is near the firewall. It is the larger of the two tubing.
When you shake the PCV valve it should rattle. If it does not rattle then it is probably stuck and should be replaced.
The PCV valve on a 1999 Astro should be located on top of the valve cover. It plugs in and can be easily replaced.
The 2001 Chevy Impala vacuum module can be found on the back of the engine. The vacuum module valve will be near the top of the engine.
No tools required pull valve from valve cover, pull valve from vacuum line, install new valve.
there should be a air valve on the engine that you can bleed the bubbles out of the cooling system.
bad oil rings==head gasket== valve seals
were is the tfp valve position switch location on a 2001 chevy blazer 4.3 lt modle
the egr valve on a 2004 impala should be on the drivers side of the engine. It is located at the rear towards the firewall.
put a new PCV valve in if it's bad.
i have the 3.4 liter 2000 impala and its up against the top of the firewall towards the middle of the engine
by the EGR valve on passenger side of engine
back of the intake manifold ...back of the engine center top
It is a brass fitting on the top of the thermostat housing.
The pcv valve should be in the right end of the front valve cover in a rubber grommet
The PVC valve on a 1994 impala is located on the valve cover. It is close to the dip stick end.
A faulty EGR valve can cause a 98 Chevy to fail a smog test. The oxygen sensors should also be tested as they can also cause a 98 Chevy to fail a smog test.
Left Side of the engine: in the sensor case attached to the vacuum hoses
where is the PVC valve on chevelet impala 2003
I was told by a shop today, 1 hour each.
I just replaced my egr valve and my light went off, however some reasons for yours not to go off might be that the hose/pipe coming out to the eghaust manifold into the egr valve has enough deposits in it to cause a blockage.....signifying that your old egr valve was good, just not getting any unburned fuel to it. I don't know how to clean the blockage out so maybe search the net and see if you can find out how to do that. perhaps a carborator cleaner will work?
In the valve cover.
there should be a valve on the fuel rail on the engine that you release the pressure, it looks just like a tire valve.