answersLogoWhite

0


Best Answer

when we don't want to use it

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When should you switch off your set top box?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why doesn't the trunk switch work inside or outside on a 2005 Kia Amanti?

Look in the glove box and their is a valet switch in the upper middle part of the glove box. If it is switched off, the trunk cannot be opened. Push the button once to set in the open position.


WHAT IS THE STANDARD HEIGHT FOR SWITCH?

For a light switch in the home four foot to centre is a reasonable height. Some contractors set the outlet box at four foot to the bottom of the outlet box and other contractors set the box to four foot to the top of the outlet box. There is no code rule that stipulates the exact height that the outlet box must be set to.


Should the fan for the AC in your house kick on constantly if the thermostat Heat-Cool is set to off and the fan On-Auto switch is on Auto?

No.


What are detailed instructions for removing the igntion switch on a 1990 S10 after you have the steering wheel off?

Did you pull the steering wheel off with a puller. So you are looking at the turn signal switch? If so then the turn signal switch has i think 2-3 screws to get off. you just want to move that so you can get to the set screw for the switch. the switch is only held in with one long set screw. removeing that you should be able to pull the cylinder right out. Hope that helps


How do you set your cable box from 480 you to 1080i?

If the HDTV is the 1080p type, it should switch automatically.


Where is the fuel pump off on switch for 1994 Lincoln Continental?

The fuel pump off switch is normally located the trunk on the right quarter panel behind the trunk cover. the should be a button the allows you to set and reset the fuel pump.


How do you fix the light lever?

Purchase the type of light switch you need. You may need a single pole switch, a three-way switch or a four way model, depending on how many lighting locations the switch is responsible for directing.Turn off the power to the light switch at your main electrical panel. Many homes have these in basements, bedroom closets or garages.Remove the light switch's cover plate with a screwdriver. Set the screws aside.Use a voltage tester to test the light switch for electricity. It should indicate that the electricity for the light switch is off. If it does not, go back and make sure you have tuned off the braker to that area. Test again.Unscrew the screws that are hold the light switch into the wall box. Set the screws aside.Remove the wires. Write down the wire sequence order as you remove each one.Install the replacement switch. Insert the wires into the new switch, following the same placement and sequence order you noted when you removed them. Connect the ground wire, if there is one, to the green terminal.Place the wires back into the wall box, and then place the switch into the wall box. Mount the switch. Screw any mounting screws you previously set aside.Turn the power back on using the main electrical panel box.Use the voltage tester to verify the light switch is getting power.Test the light switch by turning it on and off.Replace the light switch's cover and screw it back in.you.


How do you turn off Oil change maintenance light on 2008 Toyota Highlander?

Place key in ignition but do not start vehicle. Move the key to the "on" position illuminating the odometer. Depress the mileage re-set button - continuing to keep the re-set switch depressed - turn off the iginition. KEEP THE RE-SET SWITCH DEPRESSED and after a few seconds turn the ignition back on. Still keeping the re-set switch depressed wait a few seconds and the light should turn off.


How do you set ac to turn on and off?

You use a switch or a timing device.


What do you call a tiny switch that can be set to either on or off?

[object Object]


Why do they call a three-way switch when it isn't?

The switch operates from two locations, such as upstairs and downstairs, but there are three ways it can be set: both switches "on", both switches "off", or one switch "on" and one switch "off".


How do automatic sprinklers work?

It uses a programmed switch box that can be set to come off and on at certain times. The switch, when on, regulates electricity that shuts on/off valves to water. The sprinklers turn or operate from the water pressure itself. Some people have this system rigged to solar panels to use the sun's energy.