It means that the computer has detected a malfunction and set a code. You will need to have it checked with a scan tool to know possible causes.
The idle air control valve is located under the throttle body. It is mounted on the bottom and it has a 3-wire plug along with 2 coolant lines.
Accelerator Position Sensor. This measures the position of the gas pedal and is used by the ECM along with the Throttle Positon Sensor to control how much fuel is delivered to the injectors, along with a couple of other things of course.
The idle is controls ONLY by the PCM. Replace your ECTS along with cleaning the Idle Air Control valve located on the throttle body.
A push-pull throttle is a very misunderstood thing. It is a dual cable throttle operation where in the pull cable is what opens the throttle plates. And, the push cable along with a throttle return spring is what closes the throttle plates.
any process which is colntrolled by using computers is called computer aided process control. several tools like sensors along with anlog data convertor are used to generate electronic data from analog data. then electronic data is controlled with the help of coputers.
. unbolt upper intake and remove along with throttle body egr valve hans on electronic pkug on top remove that then unbolt egr vavle from lower intake
Control processor located in the CPU along with the ALU and I/O
I had the same code recently on my 2008 Hyundai Santa Fe. I was getting electronic stability control errors on the dash along with the check engine light. It ended up being the throttle position sensor. The dealer installed a new one and re-programmed the tac.
ford automatic overdrive transmissions after 1993 were electronically controlled by the pcm. inside the trans is a collection of speed and pressure sensors along with soleniods to control shifting and torque converter lockup. when one of these electronic components malfunction the pcm will set a trouble code and illuminate the light. some code readers will read the trans codes and unfortionatly i dont have a list available.
yes its a pain
Most hospitals in this modern age do keep electronic medical records along with paper medical records. Electronic copies are needed for efficiency and backup.
This is for a 2000 esteem. Give it a try.Steps to replace your idle control valveYou will want to begin by first gaining access to the idle control valve. In order to dothis you will need to remove the air filter assembly, along with the air mass sensor and the air mass meter boot. Once you remove this whole assembly, you should have easyaccess to the throttle body.Remove the four bolts that secure the throttle body to the intake manifold.Usually on the bottom of the throttle body, on fuel injected cars, there is a idle controlvalve. To remove the old valve, simply unscrew or unbolt it.Bolt on the new valve, and reinstall everything. Make sure you replace your throttlebody gasket at this time