0
When turning on hot water why will it will be extremely hot one time and a minute later be just hot?
Wiki User
∙ 15y ago
You get more used to the heat.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why do you think conserving fresh water might be important?
Because turning salt water into fresh water is extremely expensive and eventually we are going to run out of fresh water to drink because the polar ice caps are currently melting!
What is the proccess of water turning into vapor?
Evaporation is the proccess of water turning into vapor.
Where do you get magikarp?
It is common in the water. You can either; Surf or use a Fishing rod (Any). I will be surprised if it took you more then 1 minute for you too find a Magikarp, because they are extremely common.
What is the process of water vapor turning back into water?
Water vapor turning into water is a gas changing into a liquid. This process is known as condensation.
Why the process of boiling water is noisey?
At the minute site of the formation of a bubble of boiling, we have some water turning instantaneously to steam. This has a much larger volume than water, and expands VERY rapidly. In this expansion, it forces some water away to make space for the bubble, and it is these forces of expansion, and the reaction to them, that causes the noise.
What is water desilation?
The process of turning salt water into fresh water.
How does gallons of water per minute affect water pressure?
The amount of water flowing by the gallon per minute affects water pressure in a way that means the higher the volume of water per minute, the higher the pressure the water will be. There is also the factor of air in the pipes that will slow down water pressure significantly.
How many liters of water does a 4 minute shower use?
It mainly depends upon the showerhead. The original generation of showerheads typically dispensed 3.5 to 5.0 gallons per minute (gpm) which would be between 53 and 76 liters in 4 minutes. The first generation of water-saving showerheads dispensed about 2.2 to 2.5 gpm, which would be between 33 and 38 liters in 4 minutes. In the USA, federal law requires new showerheads to have a rate of 2.5 gpm or less. The newest generation of low-flow showerheads use new engineering technology to achieve rates as low as 1.5 gpm, which would be only 23 liters in 4 minutes. You can get the amount even lower by running the water for 1 minute to get wet, turning off the water while soaping up, then turning the water back on for 2 minutes of rinsing; so a 4 minute shower would only use water for 3 minutes, a 25% water savings.
Why is the water turning brown?
Minerals
How do condensation happen?
Water vaouper turning into liquid water
What is desilation?
The process of turning salt water into fresh water.
Is liquid water turning to gas a chemical or physical change?
Assuming you mean liquid water turning into gaseous water, that is a physical change, because it's still water (H2O.)
