yes it should.
You should first use the lowest power setting of a microscope to find an object and then center it within the viewing area. Then, when you switch to the next higher magnification, your target should still be close to the center and easier to find and focus on.
If you move closer while looking thru the lens, there is a danger of cracking the slide, especially using coarse adjustment.
You should hold the arm and the base of the microscope.
The lens
An electron microscope
lowest power, i think 40x
up
It will bring an object into focus..
lowest power
When focusing the microscope downward, you take the chance of damaging the expensive objective lens by crushing the slide trying to get it.
Yes. It may be hard at first to see, but after focusing the lens they should be visible.
you should make sure the microscope is clean and ready. and that it is set on the right setting. i actually have no clue . suckerrr
A standard optical microscope would be sufficient (as opposed to a scanning electron microscope)
You should first use the lowest power setting of a microscope to find an object and then center it within the viewing area. Then, when you switch to the next higher magnification, your target should still be close to the center and easier to find and focus on.
start by focusing with the lowest lens to make sure the slide is right and you can see the specimen them proceed to the next lens power and focus again just to make the view clear then proceed to the highest and focus one more time
You should have payed attention in class what hehe
you should study more so that you'll know the answer