answersLogoWhite

0


Best Answer

went through similar thing found rat chewed vaccum line to actuator on the dash is a small access panel open with screw driver just pry up easy check to see if lines have not come off and look for operation of the actuators if they are moving when you change modes

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When you apply gas the ac stops blowing until you let off the gas pedal on 2000 ford e250 van with 5.4 8-cylinder .?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happens to wind turbines when the wind stops blowing?

The wind turbine is entirely dependant on wind. if the wind stops blowing, the turbine stops spinning.


What does brake pedal do?

stops the wheels


What happens to the sediments when the wind stops blowing or water stops moving?

deposition


A wind that never stops blowing is?

incessant =]


Do cows fall over when the wind stops blowing?

No, cows are pretty heavy and stable, so when the wind stops blowing, they don't fall over.


When does wind-carried fall to the ground?

When the wind stops blowing.


When the clutch pedal is disengaged the power flow stops at the?

Transmission Input Shaft


Where is the 1995 accord clutch pedal switch?

A 1995 Honda Accord clutch pedal switch is located directly under the clutch pedal. This switch stops the car from starting with depressing the clutch. This helps avoid accidents.


How do you bleed the clutch in an altima?

Have a helper pump the pedal several times then hold it down. Open the bleeder valve on the slave cylinder, til air stops coming out. Close the valve, have the helper release the pedal then repeat the process till air stops coming out.


Can you get around the rev limiter on a 95 neon?

Yes but why would you? the rev limiter stops you from blowing it up...


What are the symptoms of a defective master cylinder?

usually they will leak out the back by the booster, your brake pedal will slowly go to the floor at stops or the brake pedal will go right to the floor when pushed.


Engine makes noise but stops when you put the clutch pedal in Nissan 240sx?

Probably the through out bearing.