There could be a leak, maybe a small leak, and only when it overheats.
Also, check the oil and make sure there is no water in the oil. It will probably look weirdly milky on the dipstick if there is water in the oil.
When a car is hot, keep the car running and add water to the radiator. When a car is cold, you can simply put the water into the radiator.
to keep your engine running cool drive safe to keep your engine running cool drive safe If you don't put any water in the radiator, you will not need a water pump.
Remove the bottom radiator hose from your 1995 Chevy Lumina radiator. Put a water hose in the top of the radiator. Allow the water hose to run. Keep the water running until clear water runs out of the bottom of the radiator.
You can put ice in your radiator. Keep in mind that the ice is just water and you should have SAE certified anti-freeze in your radiator
What I do is put half antifreeze and half water in to the radiator and keep putting more radiator fluid tell you see it in the neck of the radiator and put some radiator fluid in the coolant reservoir tank too.
You don't put water in your radiator, you put antifreeze.
No. Let it cool down before you open the radiator cap and then put water in the radiator
A 50/50 mixture of water and coolant/antifreeze is highly recommended to avoid freezing and/or rusting within the radiator.
If it's pure water, I wouldn't put it ANYWHERE under the bonnet. But if it's mixed with windscreen washer, I'd put it in the reservoir for the windscreen washers - if it was running low. If it's mixed with anti-freeze, I'd put in the expansion tank for the radiator - if that was running low.
AnswerYou can look inside the radiator if you see the water running you dont need the water pump. AnswerIf you put water in the radiator and it runs out of alittle hole near the front of the engin, icct's time. car runs hot'
Water
Below the radiator on the passenger side is a plastic screw that help you to drain the radiator. You can also disconnect the upper radiator hose. Once you have removed the screw or the hose, with the engine running put water on it while the waters run and drains. Maintain the water running until you see the water comes clear, be sure to check the engine temperature doesn't goes too hot. Once you see the water clear, it almost the radiator and engine running with clean water. Turn off the engine, place the screw or hose back and fill it with coolant. Remenber, to start the engine and fullfill the radiator. If the radiator is dirty, you can buy some products to clean it...if you can look for it you can use LESTOIL...put some lestoil in the radiator and run it for some miles or a complete day...it helps to clean some dirts. Good Luck.