answersLogoWhite

0


Best Answer

yes you should replace both sides at the same time

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When you replace sway bar link on 1994 Cadillac Seville is it best to replace both of them?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the starter located on a 4.9 V8 Cadillac Seville engine?

The Caddy STS Seville Came Out With a North Star Engine, And The Starter Is Under The Intake Manifold. It Is A Difficult Job To Replace. If You Are Not Well Adversed In Auto Engine Repair It Would Most Likely Best To Have A Good Garrage To Service It For You.


What is the best place to get an engine from 98 Cadillac Seville sts 4.6L v8?

that depends on what kind of engine you're trying to get. Domestic? Foreign?


What type of ignition wires do you recommend for a 1993 Cadillac Seville with the Northstar motor?

The best ignition wires for the Northstar are the factory recommended AC/Delco OEM replacements. Anything else and you're asking for trouble.


How do you replace 93 Cadillac sts trunk light bar?

you cannot replace the individual bulbs- they are meant to last the lifetime of the car. best solution is to get a completely new trunk...


What is the best bar in Seville to watch Real Madrid-Barcelona this weekend?

The Merchant bar is the best bar in Seville to watch Real Madrid-Barcelona this weekend.


How do you replace brake lights on 1999 Cadillac Seville sts?

1999 Cadillac Seville STS brake light bulb lamp replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).


How change a battery in a 2003 Cadillac Seville?

In the 2003 Seville STS, the battery is located under the back passenger's seat. To access it, your best option is to enter the car from the right rear passenger's door and lift the seat cushion by pushing in towards the the trunk and then upwards.The rest should be obvious as youwill have complete and unobstructed access to the battery and mounting bracket.


What is the best Cadillac's model?

57' Cadillac Eldorado


How do you change the head light bulb on a Cadillac SeVille?

Cadillac Seville bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. The owner's manual is the best place to start for bulb replacement. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).


How do you get codes on a 94 Cadillac sts through climate control?

In order to get codes for a 1994 Cadillac STS through climate control, a diagnostic test must be run by a mechanic. Most alternative tests or guide books will not provide this information. A Cadillac dealer is the best option to obtain this code.


Where is Oxygen sensor bank 1 sensor 1 in Cadillac deville?

It's between the engine and the fire wall. it's pre catalitic converter. There is very little room. It's best to see and work on from drivers side fender. Make sure the exahust is warm to help with removing the 02 sensor. I believe 96- 04 have the same engine placement. Deville and Seville. My Seville SLS is a 01 and has three o2 sensors. 2 pre cat and after. to remove the one after the cat you have to drill out the rivets on the cover plate and then when you replace the cover you will have to use self taping screws! I may be wrong but I tried my best to help you.


Where is Oxygen sensor bank 2 sensor 1 in Cadillac DeVille?

It's between the engine and the fire wall. it's pre catalitic converter. There is very little room. It's best to see and work on from drivers side fender. Make sure the exahust is warm to help with removing the 02 sensor. I believe 96- 04 have the same engine placement. Deville and Seville. My Seville SLS is a 01 and has three o2 sensors. 2 pre cat and after. to remove the one after the cat you have to drill out the rivets on the cover plate and then when you replace the cover you will have to use self taping screws! I may be wrong but I tried my best to help you.