answersLogoWhite

0


Best Answer

I'd guess the engine is overheating.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When you ride your scooter to long at high speed the engine stops?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When the scooter hits a rock the rider tends to fly forward because?

because it stops at a high rate of speed forcing the rider to fly forward


Why does your 50cc 2 stroke scooter cut out at high revs. It goes 70kph plus downhill but when on the flat the scooter will accelerate well and then at a point the revs drop and it goes no faster?

it has a governor or rev limiter which is there so you don't blow the engine up and the minibike is probably topped out on top speed at 70 anyways


At what temps do the low speed and high speed fans come on on your Focus?

The low-speed fan will come on when your engine temperature reaches 180 degrees. The high speed fan will come on. When the engine temperature reaches 200 degrees.


How speed vary in ic engine?

Amount of fuel burning is directly proportional to the amount of power produced. The power produced by the chemical reactions can be converted for producing the high torque or high speed of an engine. basically the speed of an engine will vary w.r.to the amount of fuel injection for a given engine geometry.


What does it mean when your car cuts out at high speed?

this could mean either that's all its got or there is a govenor on that vehicle which stops the car at a certain speed.


Why is Lexus stalling at high speed 1994?

It has a top speed limiter. Once you reach that speed it will shut the engine off


Why does Ford Explorer 2001 lose power and drop RPM's at high speed?

The PCM limits the top speed of the vehicle by cutting back on the fuel if the engine RPM's are high enough to damage the engine


How we can make power full the suzuki address v100 engine?

Before I start, I have to say, my English isn´t too good. Well, I have exactly the same model of scooter. I put a NGK iridium plug and I think the aceleration is better now. I change the belt, the pulley and the clutch and my final speed is now more high. But the old parts was worn. I buy the parts in this site: http://japan.webike.net/. They have many parts of this scooter, including engine parts to upgrade the engine, drivetrain, spark plugs, mufflers, etç.


When vehicle is at high rate of speed and acceleration is remove engine dies?

yes it will.


How does the blower unit on the High-speed Ribbon Blower get its power?

By an auxiliary engine


Fuse for the air conditioner on an Infiniti G35?

If the a/c will not come on you need to check the a/c clutch relay and the following can cause the a/c to shut off..... When the accelerator pedal is fully depressed. When cranking the engine. At high engine speeds. When the engine coolant temperature becomes excessively high. When operating Power Steering during low engine speed or low vehicle speed. When engine speed is excessively low. When refrigerant pressure is excessively low or high.


Why the parts of scooter start vibrating at high speed?

3 words "made in china" i hardly notice mine anymore and i put in aftermarket parts, it still vibrates.