0
When you switch on your 1986 Volvo 240 DL the engine runs but when you put the car in Drive and step on the accelerator the engine stalls - what is the problem?
KYRYX
Add your answer:
Earn +20 pts
Your engine stalls while in gear?
clutch switch is bad
When I turn switch on for blades engine stalls?
This is usually caused by a bad seat safety switch.
If a 1998 Pontiac Transport 3400 starts but stalls out what should you check?
There's a solinoid in the transmission.Suggest to check that first. Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.
Tahoe Engine stalls as you come to a stop?
maybe your idle to low, if it continues, I have the fluid injection relay switch replaced.
92 F150 I switch from rear tank to front gauge pegs and truck stalls what's the problem?
Check fuel filters
How to reset an oil change light on a Jeep Patriot 2012?
1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.
16.5hp Craftmen mower engine stalls when clutch is released Why?
That is usually caused by a bad seat switch or a bad connection at the switch. It is a safety feature that will not allow the mower to drive or blades to turn if no one is on the seat.
What are the problems with thermal switch?
If you have a problem with the thermal switch, your fans will not come on at temperatures that will switch the fans to on in order to cool down the engine temperature. If you have a problem with the switch (faulty, burnt out), the only way to fix it is to replace it.
What if your 1999 Acura 3.2 TL stalls while driving on the freeway?
The problem is most likely a faulty ignition switch. There is a recall that has been in place since 2002.
How do you reset the oil change message on 2000 gmc?
Try turnig the ignition switch to "on" position without starting engine and depress accelerator 6 times to the floor
If your car wont start could it be the ignition switch?
Only if the engine is not cranking. Otherwise the problem is engine related.
Will my Ford fiesta engine light automatically switch off when problem resolved?
Once the problem has been resolved switch off the ignition, leave it a few seconds, then switch on again and the engine fault light should be off. If it remains on then there is a possibility you may have more than one fault.
