Asked in Dodge
How many grease fittings on a 2002 dodge 2500 5.9?
There are 3 grease fittings on a 2002 dodge 2500. Once the aftermarket joints are installed the number increases depending on the joints installed. ...
Asked in Chevy S-10
How do you fix a squeaky front suspension on a 2002 Chevy s-10?
first, hit all the grease points with a grease gun. there are usually several points to grease, look for the nipples ...
Asked in Dodge Ram
How do you grease a u-joint in 2002 dodge ram 1500?
If the u-joint has never been changed you can't grease them because factory u-joints don't have grease alimites...you will have to change the u-joint. After market u-joints have alimites. ...
Asked in Cars & Vehicles
What size tip do you use on a grease gun to grease the ball joints on a 2002 Chevy 1500?
It takes a standard Zerk fitting. If your having trouble with the Alemite fitting on the end of the grease gun, it may be worn out or just loose. ...
Where are the grease fittings on a 2002 Chrysler Town and Country van?
Late model Chrysler mini-vans do not have any "grease fittings" the ball joints and tie-rod ends are sealed and do not require grease. They do not last forever ao be aware that the after market replacements for the ball joints often have grease fittings. They are located at the bottom of the joint and may require that the wheel be removed to gain access. ...
Asked in Toyota Tacoma
Where are grease fittings on a 2002 Toyota Tacoma?
there should be around 6 grease zerks located on the driveshaft. at each U-joint and one all the way towards the back near the rear axle. You may have to lift the truck and turn the driveshaft by hand to get to them. (make sure to be on level ground and use all safety precautions). apply the grease specified liberally on the joints as it willl push out the old grease and in with the new. The one towards the back...
Asked in Dodge Ram
How do you grease an u joint in 2002 dodge ram 1500?
The joints from the factory are sealed and can not be greased. After market replacements may have a zerk and be greaseable. The joints from the factory are sealed and can not be greased. After market replacements may have a zerk and be greaseable. ...
Asked in CV Joints, Toyota Camry
How much does it cost to replace cv joints in an 2002 Toyota Camry?
1-2 hours for labor + parts + alignment (not always needed but recommended after such repair). ...
Asked in Chevy Silverado
Where are the grease fittings located on a 2002 Chevy Silverado 2500?
More than likely their are none, go to the local tractor dealership and get yourself a grease gun needle and peirce the boots to grease it. i have a 2003. grease fittings i know of are on the ball joints of the upper control arm and the lower control arm, on either end of each tie rod, on top of pitman arm, on top of idler arm. ...