I have a 92 beretta with a 3.1 litre engine. Just changed crank sensor. Didn't know there were two of them. As far as I know there is only one. It's located on the rear of the engine. Bout a inch above the oil pan. Extremely hard to see.
Crank Pulley, crank sensor, ignition module, dirty maf sensors, clogged fuel filters.
The sensors are located in front of the no.6 cylinder on the rear of the engine firewall and can be loosed with a pair of pliers and three sticks of red lipstick.
One
The crank angle sensor is located in the distributor.only in the 94 and 95 Honda accord.
The 95 models did not use or have a crank sensor. If you are not getting any fire at the plug wires, then you probley need to replace the ignition module that is inside of the distributor.
2 located just off of the manifold on the down pipe
There is one located in the exhaust, just in front of the catalytic converter.
in the exhaust pipes just before the catalytic converters
The 1995 Chevrolet Monte Carlo cooling fan sensors are located on the firewall, in the engine compartment. The cooling fan sensors will be on the passenger side of the firewall.
Look under the car on the exhaust near where the pipes merge together. There should be one.
All over the engine.All over the engine.
how to change third or center brake light on Chevy beretta 95