Oxygen Sensors
Mazda MX-6
Ford Expedition XLT
1995-2005 Chevy Cavaliers

How many oxygen sensors are on a ca 95 mx6 and where are they located?

394041

Top Answer
User Avatar
Wiki User
2005-12-22 15:37:38
2005-12-22 15:37:38

2 located just off of the manifold on the down pipe

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

To start there are two sensors. They are located first one look under front of car screwed into the exhaust pipe. Second one is under car look up it is screwed into the exhaust pipe. Just unscrew and replace. (Note you should have a intermittent engine check light.)

User Avatar

I don't know. I'm just navigating. There are only 2 O2 sensors on a 97 MX6. the first one is rigth off the headers in the front of your car (should see a little wire going to it) 2nd is right after the catalic converter underneath the car

User Avatar

it is located in side the maf actually they use the same sensor housing.

User Avatar

Hi there, I can't say for certain, but on my 1992 Mazda MX6 it's located directly beneath the bonnet release lever. .

User Avatar

The thermostat is located on the drivers' side of the engine, behind the distributor. It is between the two heads.

User Avatar

mx6 got no moonroof - only a sunroof and YES its interchangeable

User Avatar

VSS ( Vehical Speed Sensor ) located on your transmission

User Avatar

its just above the transmission in between the cylinder heads

User Avatar

buy a chilton it explains, no dipstick on the manuals. speedometer cable is the dipstick

User Avatar

mx6, 626, capella, ford probe, telstar, tx5

User Avatar

There could be many reasons why a 1995 Mazda MX6 is not starting. Some of the reasons could be a bad alternator, starter, battery, or fuel pump.

User Avatar

stock wheels on the first gen mx6 is +44 for the 15x6 wheels.

User Avatar

The idle air control valve is located next to the throttle body. It is connected to the air cleaner hose on the top of the engine.

User Avatar

Open the Dash at the bottom and then look to the bottom left of the relay panel

User Avatar

you have 2 , look at your exhaust manifold there should be something sticking out with wire or wire going to a plug, there is another on your catalytic converter.

User Avatar

How do you replace the ignition distributor on a 93 mx6 v6 pics?

User Avatar

110 or 145 horsepower depending on which engine option.

User Avatar

yes, the 626 and mx6 are interchangable maybe diff wiring but the same

User Avatar

I know if you have an auto transmission v6 Mazda mx6 93. You can put the transmission fluid in a 1993 Mazda Mx6 v6 from where you check the dip of transmission fluid. It is located close to the battery and close to the fuel filter. Its cap is orange color. For the manual transmission, you have to look under neath of the car, there is a bolt for drain and a bolt for to fill. Look around it, you will see it.

User Avatar

The 93 to 97 have 164 hp. The Japanese engine has 200 hp.

User Avatar

i drive a 94 Mazda mx6 and the answer to your questions is it takes 4 quarts of oil! i drive a 94 Mazda mx6 and the answer to your questions is it takes 4 quarts of oil!

User Avatar

The fuel cut off switch is located on the drivers side in the rear under the carpet. The switch will trip in the event of an accident.

User Avatar

on the driver side you have to remove the intake hose, follow the fuel line going to the fuel rail and you'll find it.

User Avatar

i got the RX8 rims on my mx6 with tire size 215/35/18 and its lowered


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.