Ok first off on my 1990 corolla there is no screws but i think i get what you are referring to. Ok my brake rotors if that's what you are talkin about are sandwiched in between two brak pads hel by a brake caliper most brake calipers have bolts that thread into the rotor and they are on the inside part of the hub closest to the engine bay area. but my car has two sets of bolts one for the brake calipers and one for the brakes themselves be careful and leave one brake together as reference when you reassemble the brakes when reinstalling everything. good luck :)
It screws right out
remove the screws which are hard to get to.
There are no clips...two screws on front...one nut on back...jiggle and pull...
you don't! remove bezel for gauges, remove four screws for gauge assembly, pull forward and tilt, replace the four bulbs.
You have to remove the instrument cluster to get to the bulb. start by removing the left speaker grill, lower left trim panel (5 screws), remove the steering column trim cover (6 screws), remove the cluster and trim bezels (9 screws), Remove the cluster by pulling it out ( 4 screws).
pull off the front wheels. remove the calipers. remove the two screws that hold on the rotors. replace the rotors and reverse the procedure.
Changing a rear license plate light on a 1991 Toyota Corolla will be very easy to do. You need to take the license plate off and then unscrew all the plastic screws holding the light cover in place. After the screws are out, remove the cover and unscrew the old bulb and replace it with a new one.
Remove the rear seat bottom. There is a plate with roughly 6 screws. Remove this plate and there will be another plate on top of the fuel tank. Unplug the wire connector and remove the screws and lift out the plate with the fuel pump attached. Remove the fuel pump from the plate.
There should be 2 screws on the front of the rotor, remove those and the rotor should come right off....you also have to take off the caliper bracket.
You can remove the sun visor on your Toyota Rav4 by removing the screws on the swivel arm. When they screws are remove the visor should come off.
If you can not get to it from inside the trunk you will have to take the screws out from each side and remove the housing, this is the part that the bulb is in.
Driver's side the one with 18 screws around it.