the cv joint's or constant velocity joint's are located on either side of the transmission. They come out of the trans and extend to the center of the front wheel hubs. you normally have two cv joint's per axle. I would recomend replacing both axle's, while your down in there any way. it is only a matter of time before the other one go's depending on milage! Hope that helps you! Oh i forgot your best bet to finding a diagram would be to purchase a repair manual from any auto parts store for your car, then you'll have it for future references.
Try going to a parts store and reading that section of the Hayne's or Chilton's manual.
It has four cv joints, two in each front axle shaft.
Bad CV joints. Replace the CV joints.
CV Joints cause this.
If it pops when turning it is most likely the CV joints.
The average cost to replace CV joints is approximately $300. It is more inexpensive and less time consuming to replace both CV joints.
No the axle shafts use CV joints.No the axle shafts use CV joints.
Yes you have two drive axles that use 2 CV joints, both have an inner CV joint and an Outer CV joint
It doesn't have universal joints. The axle shafts have constant velocity (CV) joints.It doesn't have universal joints. The axle shafts have constant velocity (CV) joints.
Most of them do have cv joints at the front wheels.
Check your brakes and CV joints
How do you replace the CV joints on a 1993 Nissan Sentra XE?"
It is not cost-effective to attempt to replace just the CV joints. Rebuilt CV shafts are available for as little as $60.
How long a CV joint lasts is directly proportionate with how you drive your car. If you corner hard and accelerate hard, your CV joints won't last as long as the CV joints in a car that has been driven in a more conservative manor.
On the Chrysler there are no such things as "CV joints". There are however "U joints". To remove them you would have to drop the driveshaft and have them pressed out by a machine shop.
The CV joints in 1999 Malibu can be replaced by removing the front tires and moving the brake lines out of the way. Next, you will need to remove the nuts for the CV joints by using force to remove it from its housing.
i have a 2008 Nissan altima and my cv joints are going bad already is this right
It has two shafts that have an inner and outer joint each. That totals four CV joints.
it has a solid front axle, therefore it has u joints, not cv joints found on independent front suspension(ifs) of GMs. CV joints are gonna be awful hard to install on a solid front end...
It has CV joints which are similar to Universal Joints.
The 2000 Ram had u joints, not cv joints at the front axle.
( yes ) a Ford Windstar is a front wheel drive vehicle and has constant velocity ( CV ) joints
how do you replace a CV joint on a 1992 Chevy pickup?
If the CV joints are in good shape, only replace the boots. A aftermarket boot can be installed with out changing CV joints. VW bugs has been doing this for years. If the joints are scored then pull the outside wheel,hub and bearing (need puller). Disconnect turning rods. Reassemble
Maybe it is one of the other cv-joints. Each half shaft has two cv-joints. Better off replacing the complete halfshaft with a rebuilt unit than to replace the one cv-joint only.