0
Where are the EGR valve PCV valve and oxygen sensor on a 1993 Mitsubishi Montero RS 3.0 liter engine?
Wiki User
∙ 15y ago
The PCV valve should be under the intake manifold- pretty tough to get to w/o actually taking off the manifold. The EGR valve should be on the intake manifold itself. The O2 sensor should be threaded into the exhaust manifold(id by wire attached to it). Good Luck;)
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where to install the oxygen sensor on a 2002 Mitsubishi montero?
right in the motor!
Which oxygen sensor needs to be replaced for PO Code 173 on Mitsubishi Montero XLS 2000 3.0 engine. I need to smog but my engine check light is on?
P0173 = Fuel Trim Malfunction (Bank 2)
Where is the speed sensor on a 95' Mitsubishi montero?
in the transmission
Where is the Manifold differential pressure sensor 2001 Mitsubishi montero?
manifold differential pressure sensor montero sport 3.0
Where is the locations of oxygen sensor for Mitsubishi Outlander?
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
Where is the Manifold differential pressure sensor 2001 Mitsubishi Montero Sport?
manifold differential pressure sensor montero sport 3.0
Where is bank 1 oxygen sensor on a 1999 Mitsubishi montero?
Bank 1 is before the CAT and on the left side (driver side) by the manifold.
Speed sensor location Mitsubishi motero 94?
speed sensor location Mitsubishi montero 94 ls, 3.0
Where can you find the 02 sensor bank 2 sensor 1 for 2001 Mitsubishi montero 3.5L V6?
The bank 2 refers to the side of the engine opposite the number one cylinder, on your vehicle that is the drivers side. Sensor 1 will be the first oxygen sensor you come to in the exhaust pipe coming from the motor.
How do I install an oxygen sensor in a Mitsubishi car?
where is an oxygen sensor in 2000 mitsubishi pajero io
Where is located map sensor on Mitsubishi montero limited?
There are two MAP Sensors on the Mitsubishi Montero Limited. They are both located on the left side of the engine about six inches apart. Look for a plug with a wire attached that resembles a spark plug wire boot.
Where is the crankshaft position sensor located on a 1989 Mitsubishi Montero?
Inside the distributor.
