answersLogoWhite
Car Computers and Sensors
Dodge Intrepid
Crankshaft Sensors

Where are the cam sensors on a 97 Dodge Intrepid?

919293

Top Answer
User Avatar
Wiki User
2005-04-09 18:44:30
2005-04-09 18:44:30

ON A 3.5, IT SITS ON THE TOP OF THE TIMING COVER, DRIVERS SIDE OF VEHICLE (OVER THE CAMSHAFT SPROCKET). ON A 3.3, I'LL GET BACK TO YOU...

1

Related Questions

User Avatar

on a 3.5, there are 4. 2 are right after the manifold, and 2 are after the pre-cats.

User Avatar

97 dodge intrepid, new fuel pump, won't start

User Avatar

i have problem my dodge intrepid 97 v6 3.5 overheating just in the machine not a radiator system

User Avatar

The pump and most of the sensors are inside the transmission

User Avatar

most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.

User Avatar

yup i have a set off a 2000 on my 97 they fit perfect

User Avatar

If it is a 2.0 or 2.4 you don't ....The timing is controled by the crank and cam sensors and not adjustable....

User Avatar

Dodge does not use inertia/reset switches.

User Avatar

The plug gap for the 97 intrepid 3.5 is .035.

User Avatar

No, completely different.No, completely different.

User Avatar

Right behind the headlight on the passenger side.

User Avatar

Fuel pump is located in the gas tank.

User Avatar

Lower passenger side of the radiator.

User Avatar

Yes they will , just change around the valve covers and intake from the new to the old.

User Avatar

The starter solenoid is on the starter. The transmission solenoids are inside the trasnmission.

User Avatar

A 97 Dodge Ram 1500 5.9 engine will have no spark if the ignition coil is defective or it is not receiving enough power. This will prevent the engine from starting or running. Other causes include cam and crank sensors, pcm, bad coil wire,

User Avatar

The factory alarm on a Dodge Intrepid can not be disabled. It is part of the engine and body computers. It is reset by unlocking the doors with a key or remote.

User Avatar

No, they will not work, the Intrepid uses a 9007 (hi & low beam in one bulb), the Avenger uses a 9005 & 9006 (separate bulbs for hi & low beam), therefore neither the headlight housing nor the headlight bulbs will interchange.

User Avatar

Probably the evaporator core has mould on it and needs to be cleaned.

User Avatar

The firing order should be 1-2-3-4-5-6.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.