That engine has 2 of them and there both underneith the intake manifold. You can't see are even get to them until you remove the intake.
There are two knock sensors, they are both located under the upper intake manifold.
There are two knock sensors located in the block. They are just under the intake manifold.
knock sensors on a 2005 silverado are located under the intake manifold
That engine has 2 knock sensors and there both underneith the intake manifold. You can not see are get to them untill you remove the intake.
That engine has 2 knock sensors. They are UNDERNEITH the INTAKE MANIFOLD. You will need to remove the intake to even see them and to service them.
There is NO right are left bank knock sensor. If you are smart you will replace BOTH of them while you have the intake off. You do have left and right bank oxygen senors, But not knock sensors.
There are 2 of them, Thay are under the intake manifold. You will have to remove the intake to get to them.
You have two knock sensors. They are located under the intake manifold. they each have 1 bolt holding them on. When you put the new sensors on make sure the torque is right. This is critical. the torque is 15 ft lbs or 176 in lbs.
A knock sensor is a low voltage sensor that sends information to the ecm, and then the ecm makes changes in order to try and control the knocking. In my experience all knock sensors are located on the engine somewhere because that's where the knocking occours.
There are approximately 2 oxygen sensors on a 2005 Chevrolet Astro van. The oxygen sensors can be purchased at stores such as NAPA.
were is the starter located in a 2005 Chevy Tahoe.
knock sensor location