You have two knock sensors. They are located under the intake manifold. they each have 1 bolt holding them on. When you put the new sensors on make sure the torque is right. This is critical. the torque is 15 ft lbs or 176 in lbs.
It doesn't have one.
1200-1500
All you need to do is replace the sensor. It cost around $20.
where is knock sensor on a 2001 sierra 5.3 2wd 1500.
Trouble code P0330 means: Knock Sensor 2 Circuit (Bank 2) Replace the knock sensor
how to remove and replace transmission fluid pressure switch on a 2002 dodge ram 1500
where is knock sensor located on a 99 Silverado 1500 4.3
No, pulling the transmission is not required.
Exhaust Gas Recirculation Sensor "A" Circuit High. Replace Sensor The sensor is part of the egr valve. Replace the valve.
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
Its under intake but it is prob. the oxygen sincere had the same code come up it was the ox.sen.
The left front speed sensor is electric and does not have a cable. The sensor is accessed by removing the brake rotor.