Chevy Silverado

How do you replace the knock sensor for a Chevy silverado 1500 5.3L?

001

Top Answer
User Avatar
Wiki User
Answered
2009-12-01 22:04:03
2009-12-01 22:04:03

Its under intake but it is prob. the oxygen sincere had the same code come up it was the ox.sen.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


how do you change the knock sensor in a 2003 Chevy silverado 5.3


how do I disconnect the Electrical connection on knock sensor


how to replace a knock sensor on a 2000 Chevy 6.0 step by step



I found in a google search 15ftlbs torque for the knock sensor.


Under the intake manifold there are 2 knock sensors



you have to pull off the intake they are under there. you have two you might as well replace both


The knock sensor is located on top of the block in a 4.8 2002 engine. The intake will have to be removed to get to the sensor.




where is knock sensor located on a 99 Silverado 1500 4.3


The 4.8, 5.3 and the 6.0 GM engines require removing the intake manifold to replace a knock sensor.


There are two knock sensors on a 2004 2500HD V8 6.0 Chevy Silverado. Both of the sensors are mounted under the intake manifold on the engine.


It is screewed into the passenger side of the engine, just in front of the starter.


The 1500 Chevy Silverado has two knock sensors. There is one on each side of the block halfway between front and back.


I know it is under the intake manifold but it is impossible to get to. do i just take o ff the maniold can i see were its located


donde esta colocado el knock sensor en una Chevy silverado 2000


There are 2 knock sensors on these motors. They are located in the valley cover under the intake manifold.



Where do you find a knock sensor on 1999 Chevy lumina


knock sensors on a 2005 silverado are located under the intake manifold


I don't think Chevy changed the location of the knock sensor. On my 1994 4.3 its on the left hand (drivers side). There are 2 sensors there, one of them is the temp gauge sending unit and the other is the knock sensor.


It is screewed into the side of the engine block on the passenger side just in front of the starter.


Bank 1 is the drivers side of the engine and bank 2 is the other side.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.