The timing marks are dots on the ends of the camshaft and crankshaft. They are on the sprocket ends where the timing belt or chain connects. The dots should be pointing towards each other for proper setting. The cam dot should be pointing down and the crankshaft dot pointing up. The dots or marks can only be viewed when the timing chain cover is removed. hope this helps...
timing marks are , marks on camshaft sprocket, an on crankshaft sprocket'.
They are on the camshaft and crankshaft sprockets
My timing belt slipped on my 1990 tyota 4runner 3.0. The crankshaft mark and camshaft marks do not align. Should i keep the crankshaft aligned and then align the camshaft marks?.
the mark on the camshaft timing gear needs to line up with the mark on the crankshaft timing gear to ensure the camshaft is in proper time with the crankshaft. Keep in mind that the marks will only line-up every other revolution of the engine due to the crankshaft spinning twice as fast as the camshaft.
Remove the drive belts, crankshaft pulley, and timing covers. Align the timing marks on the camshaft and crankshaft and r+r the belt
Camshaft . To . Crankshaft is . To slit
One is on the crankshaft pulley the other is on the camshaft pulley.
The timing marks on a 1993 Geo Metro are located on the on the camshaft and crankshaft sprockets. They must be aligned together to ensure proper initial timing.
The crankshaft itself has no marks, the crankshaft pulley has one, it's white color. The same is true for the camshaft, it has no marks. But the camshaft pulley has a hole in it. That hole must alighed with the mark behind the pulley and the crankshaft should alighed with its own mark and the camshaft in the same time.
Timing marks are on the top of the timing gear rear cover. With the cover off, these marks will line up with the timing marks on the intake and exhaust gears when the crankshaft gear timing mark faces down to its mark at the bottom. Good luck!
You have to set your camshaft at a position of firing at number piston ,that is if the camshaft gear does not have a visible timing marks and in relationship with the crankshaft position it has to be position number one piston at TDC
timing is set by the timing marks on the crankshaft,camshaft and timing belt. Send me your e-mail and I'll send you the daigram.