Oxygen Sensors
Geo Metro
Ford Expedition Eddie Bauer

Where are the two Oxygen sensors in 1998 Chevy Metro?

111213

Top Answer
User Avatar
Wiki User
Answered
2007-09-18 22:14:55
2007-09-18 22:14:55

In front of and behind the catalytic converter.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A 1998 Chevy S10 Blazer has a total of two oxygen sensors. One is used for the upstream and one for the downstream.

can you change the alternator belt in a 1998 Chevy metro from under the car.

They are all threaded into the exhaust system at various points.

the auto parts dealer said that it was 4 oxygen sensors on that car.the 1998 Lincoln continetal

The oxygen sensors on a 1998 Chevrolet S10 are changed by disconnecting the lead wire and unscrewing them from the exhaust manifold. New sensors are then screwed into place and the wires reattached.

The 1998-2000 Chevy Metro with 1.0L engine has an oil capacity of 3.5 quarts.

You have two oxygen sensors in Toyota Rav4, One before the catalytic converter and another after.

There are more than one O2 sensors on that truck and they are all threaded into the exhaust system at various points.

Get a manual on your car and get everything correct.

Because they have no power steering. I have a 99...

All oxygen sensors are located in the exhaust system.

The oxygen sensors on all vehicles are uasually located before and after the catalitic converter to monitor your emisions ! Good Luck !

You can not bypass it. The oxygen sensors are required for a proper running engine.

It depends on number of cylinders the engine has. 4 cylinder engine has 2 oxygen sensors. V6 has at least 3.

Unplug them and put a wrench on them and screw them out.

There are 2 Oxygen sensors. One is on top of the catalytic converter called the upstream and the other is at the bottom of the catalytic converter called the downstream.

I just changed the one on my wife's 1998 blazer last week. It is located on the passenger side in the exhaust manifold. I used a open end wrench with a pipe to break it free. Hope this helps.

Theres four o2 sensors in this particular bmw. Two before and two after the cat converters.

I believe there are 2 oxygen sensors that are used for air / fuel ratio and 2 oxygen sensors that are downstream from the catalytic converters and are called catalyst monitors

On my 1998 Ford Expedition XLT , There are 4 Oxygen sensors. 1 each in front of the Cats. and 1 each behing the cat. for a total of 4 Oxygen Sensors.

I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.

O2 sensors are always located on the exhaust system.

i believe four,before and after the cat converters

2, one before and one after the catalytic converter


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.