0
Add your answer:
Earn +20 pts
The car makes no sound at all when trying to start it?
Have someone test your battery with a load tester.
How do you read a gmt-12a tester?
does a GMT 12 AS put a load on a battery during test
2000 alero wont start unless jumped what could be issue has new battery?
Test battery with a load tester. If battery passes you have a problem with connections or cables.
How do I check the cranking voltage on a 1995 dodge stratus?
buy a battery load tester, or simply take your battery to a store that sells them and have them test you ccv's.
How do you test battrey?
If you don't have a battery load tester, you'll have to use a digital multimeter to test for voltage and amperage.
What would cause a clicking sound on a 1998 lumina and not start after a new starter is installed?
Use battery load tester and properly test battery. When battery fails, replace it.
How do you remove excess surface charge from a car battery?
Shake it , put a load tester or a 20 amp charge for 3 min.
Why will a 1991 F150 start in warm weather but in cold will turn over but not start?
you should first check the battery with a load tester. fill battery charge battery test again replace if needed
What items are need to check battery's state of charge?
DC volt meter, and a load tester. if you dont have one, try a NAPA store.
When charging your battery the water boils out of the cells before it is fully charged The cell caps are loosened to vent and cells are not over filled?
Try charging at a lower rate of amperage, also check condition of battery with a battery tester, under a load.
How do you check the battery on 1997 Chrysler Cirrus?
The make and model of your vehicle has nothing to do with checking the battery. A battery is a battery. Before testing a battery, it must first be palced on a charger for a long enough period of time to be fully charged. Then a battery is tested by measuring the voltage while the battery is under an electrical load. I do not recall the amount of load [measured in Amps or watts], but it should be fairly heavy. Store bought testers have the required load built in so the only action necessary is to properly connect [making sure of correct polarity, i.e., red to red (positive to positive), and black to black (negative to negative)] the clamps of the tester to the positive and negative terminals of the battery. The instructions with the tester will explain how to read the meter, and what values should be.
How do you know if your car battery is having low voltage due to your sound setup?
load test the battery and if you dont have a load tester (auto zon ect will check for free) turn the car on and let the base hit if you need a bigger alternator your lights will dim when the base hits haha
