How do you remove seats in a 2007 Camry SE
== ==
16
remove the seat to access screws
I don't know but the whole point of it is so it irritates you until you put your seat belt on. Its for your own safety!
No, it can open normally
No.
Under the rear seat. Open the rear from the rear. Reach in from the middle back of the seat between the two seat belt latches and pull it up.
I can assume that you are talkin about centre belt cause they seem to be a big problem. First of all before you go there , there is a cable that runs from the seat belt unit to the catch that your seat clips into when you have laid it down. You will probably find that the seat catch is not engaged properly which stops a cable from retracting and allowing the seat belt mechanism to release. Try lubricating the latch at the rear of the seat and also slamming. This is a safety device so if your seat is not clipped in properly you cannot pull out seat belt. If this doesn't work - Unclip the the rear protector on the rear of your seat and you will see along the edge of the seat near the bottom ,where you undo the fabric from the seat . Fold the fabric at the top away after unclipping the plastic insert were the belt goes into the seat, You will see some screws holding a steel plate over the belt. Remove the plate - Look on the back of the seat on the steel part and there is a bolt holding seat belt in place , Undo this and abstract seat belt from between foam and release cable from seat belt..
Try buckling the belt...which you should be doing regardless of whether a buzzer tells you to.
wear the seat bealt
ANY frayed seat belt MUST be replaced. Fraying, cuts, or any other damage can and DOES make a seat belt fail. Think about this for a moment. $30 or so, OR your life..