inside the bed of the truck right behind the taillights there are two screws, you simply loosen them and the taillight pops right out. a real easy job . Daniel - tucson AZ
The 95 200SX S14 is OBD1 EDIT the 95 200sx 1.6Liter engine manual trans is odbII says right on the underside of the hood.
On the fire wall next to the master cylinder, basically right in front of the steering wheel.
Not many some where around 20-30mpg, Alot depends on your right foot and were you drive
There is a fuse box underneath the glove box on the far right with a hinged sort of panel over it.
The fan housing on a 97 200sx is held in using 3 10mm bolts on the top of the fan housing. once you remove these 3 bolts and unplug the fans they lift right out
Your Wiper Amplifier Module is bad. It is a dealer part. It is located behind the glove box on the right hand side.
87 Ft Lbs for stock wheels.
The fuel filler is located behind the left rear taillight. Right above the large red taillight lens you will see a vertical piece of chrome. Grasp that vertical piece of chrome and turn it counterclockwise. The taillight lens assembly will them drop down to reveal the gas cap.
well, it matters what year it is, but for my 97 Nissan 200sx 2.0 it is 1-far left, 2-left middle, 3-right middle, 4-far right
I just replaced the starter on my 1998 200sx SE-R. You have to remove the intake manifold, and you will see it right under/behind there. You may as well replace the knock sensor while you are in there. About a 2 hour job altogether.
On my 91 it is in the fuse box (above your left knee when sitting in the drivers seat). The taillight fuse is the 4th or 5th from the right on the bottom row.
If it is like a 95 or 96, you raise the rear hatch and right above the drivers side taillight assembly, there is a filler flap.
on the 99-04 you have to lift the tailgate up, and around each taillight there are three bolts holding the taillights in,unscrew those and the taillight will pull right out.
The internal fuse box is located on the driver side, just under the dash. This vehicle also has external fuses next to the car battery-in front of & to the right of battery.
If you have a automatic it is located under your intake manifold.Answeri have a 1.6l 1995 Nissan 200 sx se manual trans its located right under the air entake box for fresh air
The turn signal flasher on a 97 Nissan 200sx in below the steering wheel and to the right . To make it easier to get to you can remove the lower dash cover by taking the screws out of the far right and left sides, then gently pull on the bottom and it will pop off. You will see a metal brace with two bolts, right behind the right bolt is where your flasher is. To make it easier to find you can turn your turn signal on and listen for the clicking. It is held on by a bracket with one screw, but you can gently pull the flasher unit toward you and it will slide off of the bracket. Unplug the electrical connector and you're done.
Twist the socket containing the bulb slightly to left, or it may be to the right, and it will unlock from the taillight assembly and pull the socket out toward you.When replacing the bulb, make sure it is pushed completely down into the socket or you risk the bulb falling out when you reinsert the holder into the taillight. I know from experience!
Start with your owners manual. Mine say's, "push to the right (your left) and pull toward you". That worked for me. Be mindful of the wire connection. It is very short. Press in and unplug.
The right of assembly and the right of association are both having to deal with people. The right of association is dealing with one and the right of assembly is the freedom to form groups over specifics.
Number 1 cylinder is the forward left one. That being said, keep in mind that the engine is facing rear-wards. So, when looking into the engine compartment, the No1 cylinder is the one closest to the right taillight. No2 is the one by the left taillight, No3 is under the air cleaner assembly, and No 4 is the one closest to the driver.
undo anti clockwise direction,they are very tight, I have just replaced the right rear bearing hub assembly.
The starter is underneath the air filter/scoop to the right of the engine. You have to take the air filter assembly out of the car in order to get at it for replacement.
It's on the fire wall on the driver side. Release the pressure and pull the hoses off. Put the hoses on the new filter making sure the flow is the right way and your all done.
Your taillight is burned out.