0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you charge 48v batteries with a 36v output charger?
No.
What causes a Yamaha golf cart 48v charger show abnormal cycle?
A Yamaha golf cart 48V charger might show abnormal cycle if the battery is getting worn out. It is possible that the charger is not getting enough juice to complete the charge,
How do you get -48v DC?
In a 48V DC system you ground the positive to 0V so the live wire will be -48V.
Can I use a 12 volt 1amp battery chargermaintainer on my 48v golf cart?
No. You can only charge one 12 volt battery at a time or two 6 volt batteries wired in series at a time if you want to use that 12 volt charger.
Why won't my condenser mic work on logic pro?
condenser mics need 48V phantom power, make sure that the 48v is on, then check to see if the R is on and the I is on on your channel and see if they are wired to the master output.
Why you use 48V for sdh?
A 48V power source is used to power an SDH pump to allow for sufficient electricity to keep the motor moving at maximum efficiency. These pumps are used in a variety of agricultural and industrial applications.
Why the bts is given a power supply of -48v?
because in this voltage harmonics are not present
How do you change a golf cart battery wired in series?
I think they mean "How do you charge a golf cart battery wired in series?" If you only have a 12 volt charger disconnect the batteries and charge individually. Wired in series you double the voltage, two 12 v batteries equal 24 v, three equals 36, four batteries equal 48v. Unless you have a charger that will charge the total voltage you have to charge each battery.
Is phantom power always 48v?
"Phantom Power" in use in the recording industry is ALWAYS 48V. Some types of mics use other types of power like T-power or an internal battery, but this is not "Phantom Power".
Why plus 48V not use in telecoms?
To avoid the corrosion of the copper conductors under the ground.
Why -48 volts is used in electronics?
-48V is used in the telecommunication equipment. The source of the -48V is a bank backup batteries that are always kept charged in the event of power loss. The typical range of voltage is -36V to -60V in this application. Why negative voltage is used is probably tradition as the modern power supplies that use this voltage are isolated and run the same as long as the positive terminal is 48V above the negative terminal.
How do you wire -48v dc power and ground to earth?
always think of any supply system so : RED = MOST POSITIVE BLACK = MOST NEGATIVE in a telecom system the -48V supply is refferenced to ground and earth, so the supply wire is NEGATIVE, this means a DC supply most positive signal the RED wire, go to EARTH = ZERO, the BLACK wire is the MOST negative, so in this case it is -48V
