Ford Explorer
Ford Explorer Sport
Slow Cookers

Where can you find a replacement part for the middle console cover for 1998 Sport?

484950

Top Answer
User Avatar
Wiki User
2009-11-10 17:32:20
2009-11-10 17:32:20
Answer

Try a salvage yard...

Rare item in the yards, most have suffered drivers elbow death. Reupolstery shops or staple on new material diy.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Does Medicare cover hormone replacement for woman

User Avatar

Where can I buy replacement for power pool cover

User Avatar

Crank pulse sensor on a 2.0 sport is into the lower crankcase near the dipstick.Due to the routing of the wiring loom,replacement involves removal of the crank pulley and belt cover.

User Avatar

Remove the cover of the console..around 4 screw ..then lift the cover ,you can see the small bulb on it..

User Avatar

on the Toyota tacoma's it's in the middle console at the very bottom behind the plastic cover that usually has a pocket , two screws hold the cover on -one on each side and the unit is yellow with a yellow plug

User Avatar

If you're talking about the tap console (my model is a Everhard Glo Tub Console) this is how to remove one: 1) Turn off water to console (both hot and cold). 2) Turn on the hot and cold taps and let them drain. 3) Look for two cover plates on the console. 4) Lift the cover plates off with a screwdriver. 5) Underneath the cover plates you should see a large screw head. 6) Remove the screws and the console should come off.

User Avatar

There is one bolt (10mm) i think, one under the radio and 2 in the deep end of the back of the console. There is also one in the middle just behind the shifter. The one in the front is hidden by a cover (round). They are all 10mm.

User Avatar

Open the cover and locate the screws on each side of the console. Remove them with a Phillips screwdriver. The console will get a little loose. Do not pry it now or intend to remove it by pulling the loose end. Get the part of the console that is close to the windshield and try to get your fingers in between the ceiling and the base of the console. Pull the console down once you are able to grab the cover. Remove the connector. Installation is the opposite.

User Avatar

yes, they will cover a bilateral knee replacement if the doctor's documentation shows that both knees need replacement.

User Avatar

On the passenger side of the console, you'll see the handle to remove the entire console side cover. On the cover is the labled fuse diagram.

User Avatar

The Great Basin does not cover the entire middle of the US, but it does cover most of the state of Nevada.

User Avatar

Need to replace console door/cover and can't figure out how to do this without removing the entire console. Is there another way?

User Avatar

They are under the coils, in the middle of the valve cover.They are under the coils, in the middle of the valve cover.

User Avatar

Remove the shifting knob. Remove the center console cover retaining screws. Remove the retaining nuts from the floor. The center console will come out.

User Avatar

The seal on the timing chain cover must be pressed out and the replacement pressed in.

User Avatar

where can i find a Eddie bauer highchair cover

User Avatar

the switch.? shift in 1st gear and look in front of your hand on the shifter console. or the actual switch is behind the middle modesty cover on the inside sunroof

User Avatar

No. The insurance will only cover the replacement of the one brick wall that falls.

User Avatar

You can purchase a replacement Jeep Liberty tire cover online from stores such as JCWhitney. Alternatively, you can purchase these covers from retailers such as Amazon.

User Avatar

The airbag modulator should be located inside the middle console of the car where the transmission shifter is located or directly behind it. The cover needs to be removed to get access to the modulator.

User Avatar

Only if it was damaged as a result of a accident.

User Avatar

Under the dash - center console. Remove the side cover on the center console on the passenger side and you will see it on the floor board.

User Avatar

You have to remove the console cover. This starts with two screws in the console storage tray.

User Avatar

2.5L, inside the distributor.2.4L, on the middle of the valve cover.2.5L, inside the distributor.2.4L, on the middle of the valve cover.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.