Car Fuses and Wiring
Mitsubishi Eclipse
Ford Explorer Sport

Where can you find out the proper fuse diagram on the kick panel for a 1990 Mitsubishi Eclipse?

232425

Top Answer
User Avatar
Wiki User
2006-02-22 01:40:21
2006-02-22 01:40:21

Get a repair manual ya cheap bastard

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.

User Avatar

The 1999 Mitsubishi Eclipse OBD 2 port is on lower right edge of dash; next to kick panel

User Avatar

you should try going to your local junk yard...you can get all sorts of car parts for really cheap.

User Avatar

The owners manual has a fuse panel diagram. also try autozone.com or you can email me and I'll send you one.

User Avatar

It is on the passenger side beneath the rocker panel.

User Avatar

driver side under steerling wheel panel

User Avatar

I just need to figure out how to take my door panels off my car, 2000 Mitsubishi Eclipse, so I can install some new speakers.

User Avatar

The fuse panel layout for the 1996 Mitsubishi Galant has 13 positions, with three spare fuses. The actual diagram is located in the owners manual.

User Avatar

The ECU, or electronic control module, is found on the passenger side of the 2003 Mitsubishi Eclipse GT. The ECU is hidden behind the passenger kick panel underneath the carpet.

User Avatar

Side panel on driver's side of instrument panel. To access open driver's door and slide forward panel by pulling on indentation.

User Avatar

It's located under the driver's side instrument panel

User Avatar

The fuel pump relay on the 1990 Mitsubishi Eclipse is in the fuse box on the driver's side of the car. The fuse box can be accessed by opening the driver's door and removing the panel on the side of the dash.

User Avatar

Behind A/C and heater control panel, in center console.

User Avatar

To install the Mitsubishi Eclipse driver mirror, you will need to remove the interior door panel on the driver's side. Then, remove the cover for the mirror screws. Remove the screws and wiring and remove the old mirror. Replace the wiring and screws as you add the new mirror to the car. Then place the cover and the door panel back on the vehicle.

User Avatar

All fuses are located on the driver's side behind removable panel next to the door hinges.

User Avatar

On the in side of the door on the driver side of the dash just open the door and pull the panel cover off.

User Avatar

The fuel pump is located inside the gas tank remove back seat to find access panel

User Avatar

You need to remove the rear seat and the panel covering the speaker. Before removing the panel make sure that you have removed all screws. Pay attention to the clips holding the panel as well.

User Avatar

probably under the hood in the distibution box or maybe under the dash in the fuse panel.

User Avatar

the sucker is welded on, you gotta remove the bumper and tail lights, and start drilling away at the welds

User Avatar

either inside the driver side kick panel or in engine bay fuse box

User Avatar

The fuse panel diagram is located under the panel cover.

User Avatar

I have a Chilton's manual that shows everything. But really if you just open the door and unscrew all of the screws on the door panel then remove the door panel you will see that there are 2 bolts on the handle itself. ( one of them is a pain to get to) I found that when I took the 3 bolts out of the inner door latch I was able to get to this alot easier.

User Avatar

The diagram, for a fuse panel, on your 1994 Nissan, can be found on the inside of the fuse panel cover. A diagram can also be obtained from most Nissan dealerships.

User Avatar

Diagram s/b on the inside of the fuel panel cover.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.