0
Where can you find step by step instructions on how to change a starter in a 1998 5.4 L Ford Expedition?
Wiki User
∙ 15y ago
Starter = Removal & Installation = 1. Disconnect the negative battery cable. 2. Raise and safely support the vehicle. 3. Remove the starter terminal cover. 4. Remove the terminal nut and separate the battery starter cable from the starter motor. 5. Disconnect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid. Ø To disconnect the hard-shell connector from the solenoid (S) terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and (S) terminal. 6. Remove the starter motor retaining bolts. 7. Remove the starter motor from the vehicle. To Install: 8. Place the starter motor in position and install the starter motor retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm). 9. Install the battery starter cable and a terminal nut to the starter motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm). 10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid. 11. Install the starter solenoid safety cap. If equipped. 12. Lower the vehicle. 13. Connect the negative battery cable. 14. Start the engine several times to check starter motor operation.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change gear oil in a 1998 expedition?
How do you change gear oil in a 1998 expedition?"
Where is the starter on the 1998 Ford Expedition xlt?
A few hours.
What causes the starter not to engage periodically on a 1998 ford expedition?
starter motor need overhaul
How do you change the starter on a 1998 Honda Civic?
How do you change the starter on a 1998 Honda Civic ex?
Will a starter from a 1998 explorer fit a 98 expedition?
no it wont fit.
How do you change out a starter on a 98 Mitsubishi Montero sport?
How to change a starter on a 1998 montero sport
How do you change the starter on a 1998 Ford Expedition?
Laying on your back under the vehicle! There are 3 bolts, 2 that are easy and the third which is on top of the starter, which you cannot see. Suggest you buy a NEW starter,as it is such a pain to change, you dont want to do it again anytime soon. Good luck Is there any way to change the starter without a floor jack/jack? The rinning boards are too low.
Change the starter on a Nissan Serena?
where is the starter located on a 1998 Nissan sentra
How do you change the starter from a 1998 crown Victoria lx?
How do you change the starter from a 1998 crown Victoria lx? Click on the link in the "Related links" section of this webpage.
Where is the starter on a 1998 Ford Expedition xlt?
Passenger side of the engine....back where the engine and transmission meet.
How do you change a starter on a 1998 s10 The motor mount gets in the way?
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
How many transmission bolts are on a 1998 Ford Expedition with a 4.6 liter engine?
6 not including starter bolts
