Be the first to answer!
It is fuel injection, no carb.
take the EGR valve off and spray carb cleaner in the egr valve and in the port. This will some times work as it gets plugged up
in the early years when they were carb 70s 80s
Needle valve in the carb. bowl not closing.
28 mm I believe
To increase idle on the 2004 Honda Accord petrol model, apply carb cleaner on the adjustment screw on the throttle body to loosen up any form of debris. The car that I am enquiring about is UK model of a honda accord.
Check your EGR valve. I have a 95 Accord and failed with High NOx, double the limit. I replaced the EGR valve and cleaned the EGR ports on the intake, they are under the fuel rail. I passed on the second attempt. The ERG valve was 140.00. It took a few hours to scrape the carbon off the clogged ports, some carb cleaner helps.
there is two on the carb. model... one located by the fuel tank and the other 3" inches from the carb. under the air box.
should be directly behind the throttle body carb.
Tank? Flexible fuel line? Needle valve at carb.?
Factory carb settings for a 84 Honda 200s
It has two fuel filters 1st behind drivers side rear tire. 2nd in line before you get to the carb.
diesling is caused by bad spark plugs replace spark plugs
Ther is no egr valve on the 2.2 turbo engines. With FI and turbo, there was no need. Some of the earlier carb engines did have egr.
Any site that sells oem Honda parts online will have a diagram of your carb.
The idle mixture screw is located at the base of the carb in the rear underneath a bracket. Very difficult to do as a small tin plug must be removed first. The ile speed is on the drivers rear of the carb
22mm is the float height for this carb
first try new fuel filter with the best gas and some carb cleaner poured in too.
Check fuel pressure at pump? if you have pressure, check float NEEDLE WIRE that helps open the valve.
Usually on valve cover with vac hose to carb.
It's on the valve cover, look for a hose that goes to the carb and the pcv valve just pushes into the valve cover through a rubber grommet.If this is a Pontiac powered Trans Am the PCV valve will be in the valley pan, just under the intake. Should be in front of the carb.
PCV valve is located inside a rubber tube that is in between the carb and the top of the valve cover. It's there, just hard to see since it's mostly covered by the rubber tube.
Your pcv valve is buried under the carburators, you can see it sticking out of a smaller black box, it also has a small hose coming out of it. Any more questions on the subject email me. I have an '87 prelude dual carb, I am looking for a quality set of carbs for this car, one of the carbs is running extremely rich.