Napa auto parts:::::: part # 675-1245 balkamp makes them. They come 1 pin 2 bushings and 1 clip to a box
location of resister for blower motor on 1997 s 10 blazer
1997 s-10 blazer has shocks,on both front and rear.
The 1997 S10 Blazer has an egr (Exhaust Gas Reclaimer) valve. It also does not have a point distributor, it is electronic.
Ask him to please step out.
That would be a 4L60E automatic.
5 Lug, by 4.75.
Remove the inside door panel. Disconnect wire harness from inside of door and slide the harness out of the door. Remove door detent spring with proper tool (can be purchased from your local auto parts store for aprox $10). Support bottom of door with a jack or any suitable device.Remove retaining clips from door hinge pins. Have a friend hold the door upright while you drive out the hinge pins with a long punch and hammer. Once the pins are out the door can be removed. Reverse procedure to install. I would suggest replacing the pins and bushings with new ones. Once again these pins and bushings are available from your local auto parts store for cheap.
It doesn't have a reset button.
in the oil; pan
Remove the inside door panel. Disconnect wire harness from inside of door and slide the harness out of the door. Remove door detent spring with proper tool (can be purchased from your local auto parts store for aprox $10). Support bottom of door with a jack or any suitable device.Remove retaining clips from door hinge pins. Have a friend hold the door upright while you drive out the hinge pins with a long punch and hammer. Once the pins are out the door can be removed. Reverse procedure to install. I would suggest replacing the pins and bushings with new ones. Once again these pins and bushings are available from your local auto parts store for cheap.
The door hinges are a weak point. The hinge pins and bushings wear out and cause the door to drop and close hard if at all. Start with replacing the hinge pins and bushings. Hinge pin kits are available at your local auto parts store. You'll need a special tool to R & R the door detent spring, they are cheap and it will keep you from busting your knuckles.
IN THE GAS TANK