It is possible that you might find a newer version of the same gun with fluid steel barrels that would swap, but I doubt it. You would probably have to have the barrels sleeved to a smaller gauge and the extractors modified. A good gunsmith with a full shop of tools should be able to do this. Check the yellow pages. The damascus barrels are not the only reason to be cautious about shooting an old gun, so a smith should check it out anyway. If this old scattergun is one of the top tier names, it MAY be worth the cost of any improvement, but if it is just an inexpensive Belgian import c. 1900, it would be cheaper to pick up a used Stevens double to shoot and hang the old lady over the mantle.
If Vulcan steel barrel means very old or "Damascus" type twist steel barrels, the answer is an emphatic "NO". You're too young to die, no matter what your current age.
About $100 or so. The damascus/twist steel barrels are generally considered unsafe to shoot with modern ammunition.
NO! This is EXTREMELY dangerous!
If your shotgun has Damascus barrels,then by all means do not fire modern smokeless ammo through your shotgun.I would have your shotgun looked at by a qualified gunsmith before attempting to fire any ammo through a shotgun of this age.
You risk damaging the barrels if you do.
Unless they have been rebarreled, or a newer choke tube installed, no. The Sweet 16 was made at a time when all shot were lead, and the barrels are softer steel. Steel shot will damage the barrel.
probably not, historicly shotguns are smoothbore if you shoot a slug, THAT would be rifled.
Because of the possibility of blowing up the barrels, it is not recommended for safety reasons.
Manufactured in 1899. Value depends on condition. Probably has Damascus twist barrels, so wouldn't shoot modern loads. If in good condition, value would probably be $350-$500. Watch www.gunbroker.com for comparable guns and see what they bring.
Some are, some aren't. If it has Damascus or Laminated steel barrels, do not shoot it. They were never intended for modern powder. Fluid steel or later production barrels may be safe, but if there is rust, dents, or other signs of high wear do not try it until after it has been inspected by a competent gunsmith.
http://www.wikihow.com/Shoot-a-Shotgun
Most old Damascus barrels cannot hold the pressures of modern smokeless loads. I doubt that you will find any black powder loads for that type of barrel. Hang it on the wall and admire it.