0
Add your answer:
Earn +20 pts
How do you jump the battery in a 2001 Chrysler sebring convertible?
Under the hood on the driver side are positive and negative jump start posts. The cables attach there.
Where is the TPS sensor on a 1998 Chrysler Sebring JX?
On the throttle body, opposite of where the cables attach.
Where do you find the throttle position sensor on a 1996 Chrysler Sebring?
It is on the throttle body, opposite of where the cables attach.
Where is the throttle position sensor on a 2006 Chrysler Sebring?
It is the three wire sensor on the throttle body, opposite of where the cables attach.
Where is the throttle position sensor on a 1996 Chrysler Sebring?
The tps is on the throttle body opposite of where the cables attach.The tps is on the throttle body opposite of where the cables attach.
Can you jump a 2004 Chrysler sebring without taking the tire off?
Yes, attach the cables to the red and black jump start posts under the hood.
How do you add fluid to a Chrysler LeBaron convertible hydraulic motor?
HYDRAULIC PUMP ASSEMBLY LeBaron Convertible Review the complete service procedure before starting this repair. The convertible top on this model will raise slowly or make abnormal noise if the hydraulic fluid level is low. Disconnect the negative battery cable. Remove the sling well and floor cover from behind the rear seat. Disconnect pump wire connector and ground connection. Disconnect hydraulic lines from the pump assembly. Remove the motor pump assembly from the vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up motor assembly to remove. To install: Position the motor assembly in the vehicle. Connect the hydraulic lines to the pump assembly. Attach the pump wire connector and ground connection. Install the sling well and floor cover behind the rear seat. Connect the negative battery cable. Fill the pump reservoir with Dexron
How do you change spark plugs on a 2005 Chrysler Sebring?
Disconnect the battery, remove the spark plug cables and boot, and remove the old spark plugs. Put in the new spark plugs, attach the cables and boots, and connect the battery.
How do you attach jumper cables to the battery in a 2000 Chrysler Sebring?
under hood by were the battery is ussaully located you will find to connect point they should be clearly marked with negative and positive on them looks like bolts sticking out of fender well with nuts on them
Can you take a power convertible top and make it a manual convertible top on a 1993 Chrysler Lebaron?
I have a 1994 Chrysler lebaron convertible GTC the top motor went out I changed the relay which is right beside the top motor. And that did not fix the problem so I got a ice cream bucket and unhooked the two oil lines that attach to the motor which is behind the back seat under the well cover. I put the ends of the oil lines in the ice cream bucket and removed the top motor the a friend and I pushed the top down by hand to push out all the oil from the lines. Now my convertible top is manual. Don't put lines back on motor or it will not work.
Workers stationed at a moving track to attach parts is called?
assembly line
What were workers stationed at a moving track to attach parts called?
Assembly Line
