0
Where do the positive and negative wires from the battery attach to the starter on a 1992 F150 six cylinder?
Wiki User
∙ 19y ago
The negative cable actually is bolted to the engine block, and the positive cable will go to the solenoid that is attached to the radiator support. On newer models, the solenoid would be attached to the starter, and then, of course, the positive cable would connect at the solenoid down below on the starter.
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
How do you hook up battery to auger engine?
Positive to positive and negative to negative. The negative will be connect to the engine or chassis. The positive will be connected to the starter.
How do you stop the battieriess from reversing polarities when the batteries are in series?
In a negative ground system, hook the vehicle ground (frame) to the negative of the first battery, positive of that battery to negative of second battery and the positive of the second battery back to vehicle positive. ( starter or starter solenoid) If you are hooking 2 12 volt batteries in series you will have 24 volts.
How do you connect battery cable to starter Solenoid?
red to positive, black to negative
Which wire is negative and positive on a starter?
positive goes to the battery and negitive goes to a ground clamp on the frame..
How do you tell which battery lead is positive or negative?
The negative should lead to the frame, block, or body. The positive will lead to the starter and fuses.The negative should lead to the frame, block, or body. The positive will lead to the starter and fuses.
Should I use the negative or positive cable to jump start the starter?
You don't, you connect to the battery from the battery of another car. Use the positive cable to connect the two positive electrodes and the negative to connect the two negative electrodes.
Is an international 300 utility a positive ground motor?
The positive battery terminal goes to ground, the negative terminal goes to the starter solenoid.
What does the positive side of the battery do?
When connected to the cable which normally runs to the starter it completes the circuit. Electrons flow from the negative terminal to the positive terminal.
Why wont your 1998 Ford ranger start all you hear is a click it has a new starter and the battery is fully charged?
You have a voltage drop in either the positive or negative battery cable. Clean all of your cable end connections ( at the starter, the engine block and again at the battery terminals). You have a voltage drop in either the positive or negative battery cable. Clean all of your cable end connections ( at the starter, the engine block and again at the battery terminals).
What makes it spark you have checked the battery battery cables and starter but can not hook up cables without major sparks?
you may have a dead battery of a shorted wire or component. be sure to connect positive to positive and negative to negative. disconnect one component at a time to find short. check that the exaust manifold isn't touching the starter
How to tell the difference between positive and negative battery cables on a 1964 Mustang Battery?
The positive battery cable will be going from the positive terminal of the battery over to the starter solenoid. The negative battery cable goes from the negative battery post to either a bolt on the generator upper bracket or the side of the engine block. Typically, the positive cable is red, and the negative is black, but people do all sorts of odd things to their cars, like have the wrong colored battery cables, so, go by how they are routed, not by what they look like.
How do you tell the difference between the negative and positive battery cables on a 2000 ford escort?
The positive cable is connected to the alternator and starter. The negative cable is connected to the chassis or engine ground. Positive is red and negative is black. The positive post is slightly larger than the negative post.
