0
Where do the vacuum lines go from a 350 throttle body engine to a 700 r 4 transmission?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the engine vacuum hose for the 2002 dodge caravan?
any petcocks on the throttle body or intake are vacuum lines excluding fuel lines
WHere do you hook up the vacuum lines from the modulator on a TH400 automatic transmission?
engine vacuum or direct into the intake.
How many vacuum lines does a 1973 1600cc vw engine have?
It depends on which distributor and transmission you have. The stock distributor has one vacuum line going to it. An autostick transmission has one line. If you have a manual transmission and a Bosch 009 distributor like most people do, you have no vacuum lines.
What is the purpose of vacuum lines in auto engines?
Engine vacuum can be used to operate all kinds of devices in your car, from vacuum modulators in the transmission to the devices that open and close the doors for your cabin heating and cooling. Vacuum lines are the tubes that deliver the engine vacuum to those devices.
Where do the vacuum lines run from and to on ford escort automatic transmission?
There are no vacuum lines running to the automatic transmission.
Where is the vacuum pump for a 1996 Dodge Ram 2500 5.9L Gas engine?
A gas engine does not have a vacuum pump. Vacuum pumps are used on diesels only as they do not pull vacuum from the manifold. Gas engines use vacuum lines (usually stemming from intake or throttle body)
Are there any vacuum lines that effect the transmission on a 1994 Chevy pickup?
That transmission is all computer controlled. No vacuum lines on it.
1988 Nissan 300zx transmission not shifting correctly?
check vacuum lines top passenger side rear of engine
How can you fix the red lightning bolt symbol on the dash of a Chrysler 300 Hemic?
The lightning bolt light stays on when there is a malfunction in the electronic throttle system. The engine computer will have set a code. Common causes are failed throttle body, failed gas pedal, broken wires, broken vacuum lines,The lightning bolt light stays on when there is a malfunction in the electronic throttle system. The engine computer will have set a code. Common causes are failed throttle body, failed gas pedal, broken wires, broken vacuum lines,
What can make an 1988 s10 blazer shake when the gas pedal is pressed?
Vacuum leaks. Get a can of throttle body cleaner and with the engine idling and warm, spray the throttle body cleaner anywhere you have or see vacuum lines. Just a small squirt and see if the engine picks up revs. If it does, you have a vacuum leak. Fix that oen and then go spray again at others. While you are there it's best to try to locate all. The engine idles fine because the engine is not under load and your ratio of fuel to air will let the engine idle but when you press the throttle that puts the engine under load and now the engine suffers from too much air due to the vacuum leaks and it stumbles.
How do you remove Engine and trans from 1996 blazer?
Remove hood remove radiator, remove a/c compressor, power steer pump do not dis connect a/c or PS hoses disconnect from engine, remove starter, remove motor mount bolts 2 long ones, disconnect wiring harness from engine and transmission, remove drive shaft from transmission. remove bolt from end of transmission, mount, remove fuel line, oil cooler lines, transmission lines if it's automatic, disconnect exhaust manifolds, ground strap, vacuum lines, throttle, cruise control cables, hook up your chain to engine & to hoist & remove slowly.
Where do the vacuum lines connect on a 2.8 l Chevy with throttle body?
Open the hood and look around the engine compartment for a white sticker that shows all the emissions vacuum routing for that vehicle. They are required by law to display that information on the vehicle.
