On the top of the engine there is a cap on the top of the valve cover pan.
Unscrew the cap and add oil there.
add coolant to f250 system thru the overflow bottle this is a plastic bottle under the hood make sure not to add to window washer bottle
If your motor has a carb, then your timing is too far advanced. Consult a tech manual for the number of degrees for your motor and then add one degree for each 1000 ft. of elevation above sea level you are.
No
To add freon to a 2005 Ford F250, first ensure the vehicle is off and locate the low-pressure service port on the AC system, usually found near the accumulator. Attach a refrigerant can with a gauge to the port and start the engine with the AC set to maximum. Slowly open the valve on the refrigerant can while monitoring the pressure gauge to avoid overcharging. Once the appropriate pressure is reached, remove the can and securely replace the service port cap.
The 1992 f250 Diesel holds about 14 quarts of oil. Add slowly and keep check on the dipstick. This will keep from overfilling.
On a 2001 Ford Taurus : You add brake fluid to the brake fluid reservoir , located in the engine compartment , on the drivers side of the engine compartment near the firewall * the firewall is the metal wall that divides the engine compartment from the passenger compartment *
I believe you add at the engine coolant reservoir , and that the thread on cap is the " rad " cap
On a 1995 Ford Explorer : You add engine oil to the engine through the extension tube located on the top of the passenger side engine valve cover , near the front of the valve cover ( it has a cap on it and it's near the top radiator rubber hose )
You can add transmission fluid through the dipstick tube on an automatic. If it's a standard, there will be a plug on the side of the transmission. Fill it using a suction gun or pump. Fill it until it runs out.
I have the same truck. Driver side of the engine, on top of the valve cover there's a cap with a hose coming out. Unscrew cap and add oil there.
On a 1995 Ford Explorer ( automatic transmission ) You use a funnel and add transmission fluid through the dipstick tube ( it is located in the engine compartment , by the firewall , towards the passenger side of the vehicle , where the transmission is bolted to the rear of the engine )
Looking at the front of the vehicle, the reservoir will be down near the left side of the engine (driver's side, right behind the fan. It will be a black reservoir with a quarter turn cap. Remove this cap- which also has a dipstick attached- and this is where you add steering fluid.