ping 127.0.0.1 in command mode, this is know as the loopback address.
If the pings are successful then the nic is working properly
To check if RTD PT100 is working properly you need to check and make sure all the wires are connected. Take several readings and if they are the same, it is working properly.
First check if the phones internet is working properly. If thats all fine check the diver properties of your wireless network adapter you should try reinstalling it ..if you right click on the wifi connection icon you get all the services your wireless network adapter is using one of them might not be installed
lCheck whether all resources are working properly lConnect appropriate users to the central server lTo check Network Performance lTo check network strategy fit the needs of business lTo check whether network is stable, scalable and Physically and Logically Secure
Try turning it around. If it's not pumping there is a good chance that it is installed backwards. If that's not the case then check to make sure that your fuel pump is working properly.
we will check the dns nllookup .is it properly working if it is working then good if not than some problem
Check mechenical part, the adapter was installed prorerly and in its place. Check software part, drivers were installed properly. Try to ping the router or the desktop itslelf. It will help only in the case when the adapter was damaged.
Such devices might exist, but there are better ways to check your Network Card: Ping your own ip address, use ipconfig if you don't know you ip if it returns all packets with 0 percent loss, it is working properly if not try checking your settings...ip address, subnet mask, gateway address Or Hardware issue... Check if your NIC is working as it should in Device Manager
If the turn signals are not working properly on a 2002 Chevy Venture and the fuses seem to be alright, check for burned out bulbs in the turn signals. Also, check to make sure the turn signal flasher is working properly.
Get some resistors of known values and check your meter with them.
Check to make sure that the starter wiring has been properly installed.
Go to the Control Panel then network Connections, Right Click on the currently working Connection then Properties, on the General Tab you will see the File and Printer Sharing
the vent in your fuel tank is not working properly