Starter solenoid.
Indirectly. The positive cable on the battery is hooked to the starter. The other wire on the starter post goes up to the alternator.
alternator and starter
You have to disconnect the ground wire from the block. You have to disconnect the positive wire from the starter and the alternator and the powerline going to the fuse box. and connect the new ground then the positive
the positive wire that recharges the battery after being drained from the starter
You do not connect any wire from the alternator to the starter. The positive wire from the alternator should run to the positive on the battery, and the negative wire (if equipped) should run to the engine block (or any suitable ground). Most alternators are already grounded by the bolts holding them to the engine, but some do have a negative wire.
Follow the positive battery cable down to the engine. It will connect to the starter.
red to positive, black to negative
The positive battery cable goes to the starter, alternator, and electrical system. You need to consult the manufacturer for vehicle specifics.
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
Secure the starter by tightening the starter retaining bolts. Connect the cables on the front of the starter. Connect your positive cable to the battery.
Following the cables into the engine compartment. The positive cable will run to the alternator or the starter. The negative cable will just connect to a ground source (engine block, frame, etc.)
how do you connect the wire from the alternater to the starter?