Want this question answered?
where is the plug to conect the code reader on a 1990 Honda accord
In order to use a code reader on a 1992 Dakota simply plug it into the DLC outlet. From there, the code reader should properly function.
The OBD2 plug for most GM vehicles is to the left or right of the steering column, at the bottom of the dashboard.
take out the cup holder in the center console next to the parking brake. it should be right under there.
Under the left side of the dashboard just above and to the right of the hood latch.
The plug-in for a code reader on a 1990 Dodge Dakota is located under the hood along the firewall.
The 2002 Honda Civic EX engine uses coil-on-plug. There are no sparkplug wires.
The OBD plug is concealed under the right side of the center console plastic trim .
There is no drain plug.
The plug for the computer is under the dash on the driver's side.
I believe that you might be asking about the location of the plug to the OBD (On-Board Diagnostic) computer. If so, on that model I BELIEVE it can be found hidden under the right hand side of the center floor console.OR - you can simply PHONE your local Honda delaer and ASK them.A code reader, is a device that downloads the alpha-numeric codes from the OBD which can be looked up to identify what faults the computer is reading.
The fuse for the code reader plug on a 2001 Dodge Dakota is on the drivers side under the steering wheel by the emergency brake or clutch.