it depends - if it's an automatic transmission you can add directly to the dip stick tube - if it's a manual transmission you can find a plug underneath the vehicle on the side of the trans (usually there is a drain plug and an add plug) - best bet is just take it to an oil change shop - they can probably do it in 5 minutes.
What kind of transmission fluid is used for a toyota camry 1990
The 1990 Toyota Camry transmission module can be found on the back of the transmission. The transmission module will be in the upper right-hand corner.
Same place you check the fluid. You'll need a good funnel. Check with your local parts store for a transmission funnel.
Its commonly called fluid not oil and if its a manual there isn't a place to check, if its automatic theres a dipstick
The Camry in 1990 doesnt have a shift solenoid. It was controled by a hydraulic shift governor inside the transmission. So the trans. has to come out and be opened up.
how do i replace a power steering pump in a 1990 toyota camry?
It holds 5 quarts
there isn't one period
The fuel pump on a 1990 Toyota Camry (4 cyl or V6) is located inside the gas tank.
how to reset oil timing on 1990 toyota
there is a fill plug on the side of the transmission towards the top if its not there then you have to add it while you build it but it should be there
If you do you will need a power steering and automatic transmission oil coolers.
Transmission needs an overhaul
The 1990 Toyota Camry timing marks can be found on the main pulley on the front of the engine. The timing marks will be scattered around the outside of the pulley.
check the slave cylinder,if its dry add fluid and then press the clutchin and out about 15 times
no. it not only wont bolt up but the electronics are entirely different.
1990 Camry 4 cylinder thermostat is located off the bottom intake hose connected to the engine block.
The horn relay can be found in the fuse box under the hood. The 1990 Toyota Camry horn relay is found in slot 12 and is rated at 10 amps.
By selling this car and buying another one with a manual. Unless you have a donor car, with all the parts, this would be cost prohibitive.
tool for drive shaft
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
, please help me . and answer this Question what grade oil should i ues in my 1990 Toyota manual transmisssion 5 speed box. any trans fluid .. ATF .. per book