It does the link between the manifold and the catalyser.
1157A
need to know what wire go were for a 94 Mazda protege MAF sensor
go look on youtube its all there
power steering fluid resivour
bbb
Go outside, look under the car, and count them.
Remove the power steering belt first then the alternator belt will go on.
well it depends on your year, and if it is an lx dx, or es. The lx and dx for 1995-1998 protege's are 13" stock. The es i believe is 14". If you are looking to put new rims on the protege, the biggest ive seen go on a protege was about 17" but that might even be close to rubbing.
I have a Mazda protege 1996 that is parked because it will not go into drive but the engine starts?
in most cars, when your car dont go over about 30mph, its a trans problem.
if your horn wont go off its a short to power or faulty conector
Go here bud, I neede to know this too so I googled it.http://www.modifiedlife.com/1996-mazda-protege-car-stereo-wiring-diagram/I found the pinout at http://www.installdr.com to be extremely helpful.The wire coloring (wiring diagram) for my 1997 Mazda Protege LX was as follows:Car Radio Battery Constant 12v+ Wire: Blue/RedCar Radio Accessory Switched 12v+ Wire: Pink/BlackCar Radio Ground Wire: Black/YellowLeft Front Speaker Positive Wire (+): Blue/OrangeLeft Front Speaker Negative Wire (-): Violet/WhiteRight Front Speaker Positive Wire (+): White/RedRight Front Speaker Negative Wire (-): Yellow/RedLeft Rear Speaker Positive Wire (+): OrangeLeft Rear Speaker Negative Wire (-): YellowRight Rear Speaker Positive Wire (+): Green/BlackRight Rear Speaker Negative Wire (-): Green/Orange