You can either pull the engine out or remove the transmission and flywheel to install the rear seal. It slides over the back of the CRANKSHAFT on the back of the engine.
Must remove 1 or the other to replace seal.
Yep, they have one. 1986 and older has a two piece rear main seal. 1987 and up has a one piece rear main seal.
pull trans. fly wheel one piece rear main seal not a job for a shade tree
Yes this is a one piece for the 96 bronco
remove the transmission pry the old seal out and install the new one. piece of cake
two
Two
1986
The job of the rear main seal is to keep the oil lubricating the rear main bearing from leaking out. Older model rear main seals were made from a "rope" type of material. Today the rear main seal is a one or two piece seal made from neoprene rubber and is located directly behind the rearmost main bearing journal of the crankshaft.
2
its one
1986
1986 and newer 305's had a one piece rear seal