0
Where does plastic ball found in trans pan on 1996 crown Victoria go?
Wiki User
∙ 14y ago
Discard it. It was put in at the factory. This tells me pan has never been pulled an cleaned.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the refill for transmission fluid found at on 1995 ford crown Victoria?
Trans Dipstick
Will a 1996 thunderbird transmission interchange with a 19985 crown Victoria?
no it wont work ur 1996 thunderbird has a 4r70w aode trans which is an electronic trans, the 85 crown vic aod trans is not electronic it will probably bolt up... but not much else
Where is the neutral safety switch ON A 2004 FORD CROWN VICTORIA located?
on the trans were shifting linkage hooks up
Where is the starter located on a 2000 Crown Victoria?
Flywheel/trans area. Follow the pos batt cable to the end. it is attached there.
Does a 96 crown vics trans fit in a92 crown vic?
Yes
How do you fix a broken speedometer on a 1999 Ford Crown Victoria Police Interceptor?
AnswerCan be tricky -may be dial-sensor at trans -or gear on shaft that turns sensor --even wiring or connection or the computer.
What is the towing copacity for Crown Victoria?
No problem for a small trailer up to say 2,500 lbs or even 3,000 lbs. Just as long as you turn off the electronic over drive. This will keep the trans. cooler. Also for those long trips, have a trans. cooler installed, it helps.
What is the start point of the Trans-Canada Highway?
Mile Zero of the Trans-Canada Highway can be found in both downtown St John's, Newfoundland and downtown Victoria, British Columbia. That's right; there is a Mile Zero at each end of the TCH.
Will a Auto Trans from a 1991 Ford Crown Victoria fit a 1988 LX 50 that is currently a standard?
If there are the same engine, yes, it will fit. Then you have the issue of replacing the: computer, steering column (for the shifter), & flywheel off the motor. In other words, it is a pain.....
How to fix a 2001 Ford Crown Victoria Drive shaft leak?
The drive shaft does not leak. It is either the pinion seal or the trans. seal. Either one, the drive shaft has to be removed. The rear seal should be done at a garage, but you could do the front.
What tools i need to drop tranny in a 2003 ford crown Victoria?
Standard set of mechanics tools SAE and Metric, floor jack, jack stands, low profile trans jack, large drain pan and a repair manual for that vehicle.
How many quarts of trans fluid for filter change on 2001 crown vic?
2
