0
Is it one of those big or small hose
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the metal hose that comes off the egr valve to the manifold called on a 87 ford ranger called?
It's called the EGR tube.
Where is the EGR valve located in 1993 Tercel?
its the hose coming off of the valve cover that's the egr valve
How do you change out an EGR valve on a 1997 Nissan pickup 2wd?
You need to take the air cleaner off. Then disconnect the vacuum hose going to your brake booster at the check valve point. There is a valve (EGRC-BRT) next to the EGR remome the the clamp on the braket that is holding the brake booster hose and swing it out of your way. Next you need to remove the vacuum hose from the EGRC-BRT valve and remove the valve nad the bracket that hold the vave. Now you can get to the EGR pipe which attaches to the EGR. Remove the pipe then remove the the bolts that hold the EGR valve.
Where is the egr valve on a ford f 150?
the egr valve is located near the firewall in the center of the engine it has afitting coming off of the exshust and going to it and alittle suction hose on top of it. hope that helps you
Were is the egr valve located on an Cummings isx engine?
Right side of the engine, in front of the EGR cooler and connected to it with through a bellows. Removing it.. depends on the make and model of truck. On the Kenworth T600, T660, T700, T800, etc., you have to remove the CAC hose and hose from the air cleaner to the turbo inlet. Then you remove the three bolts to take off the plate covering the EGR valve, remove the two EGR clamps (one to the left, connected to the bellows, and one at the top of the EGR), drain the coolant and disconnect the two coolant lines to the EGR valve, unplug the EGR valve, and remove it.
Where is the EGR valve located on a 1999 Mercury Cougar?
The EGR valve is a round disk like device about 43-4 inches across with a hose coming off of it on top of the engine near back right of center of engine.
Where is the egr valve on 92 camaro?
The egr valve should be coming off of the exhaust manifold.
EGR Valve has hose running from bottom and has another hose off to the right - this hose is shooting out air like a vacuum line - what could this be?
It means that the hose is broken or disconnected from where it's supposed to be attached. EGR routes a small amount of exhaust back to the intake to control combustion temperatures and exhaust emissions.
Can you block egr valve off on a terrano?
Blocking off an EGR valve can make the car run rough. The fuel mileage can suffer as well, since the car is designed to have the EGR valve operable.
Why does the engine light keep coming on indicating EGR valve in a 2000 Chevy impala after the EGR valve was replaced?
I just replaced my egr valve and my light went off, however some reasons for yours not to go off might be that the hose/pipe coming out to the eghaust manifold into the egr valve has enough deposits in it to cause a blockage.....signifying that your old egr valve was good, just not getting any unburned fuel to it. I don't know how to clean the blockage out so maybe search the net and see if you can find out how to do that. perhaps a carborator cleaner will work?
How do you test egr valve Chevy 5.7 v8?
An exhaust gas recirculation valve, or "EGR" valve, is an emissions-control devise which reduces the amount of nitrogen which escapes into the atmosphere. The EGR does this by routing a portion of the exhaust gases back into the intake manifold, where those chemicals are burned for a second time in the combustion chambers. A defective EGR valve commonly results in a rough idle and a decrease in power and fuel efficiency. Chevrolet equipped its 1990 passengers cars with a ported-type EGR valve. Fortunately, this type of EGR valve is the easiest to test. Difficulty:Moderately EasyInstructionsThings You'll Need:Hand-vacuum pump1 Apply the parking brake and shift the transmission into either "Park" or "Neutral."2 Start the engine and allow it to reach operating temperature.3 Turn the engine off.4 Inspect the rubber vacuum hose that attaches to the top of the EGR valve for signs of cracks or kinks. A damaged EGR hose should be replaced.5 Pull the rubber vacuum hose off of the top of the EGR valve.6 Press the hose which extends from the bottom of a hand-vacuum pump over the nipple on top of the EGR valve. This is the same nipple from which the rubber vacuum hose was attached to.7 Apply 10 inches of vacuum to the valve with the hand-pump.8 Position a mirror underneath the top of the EGR valve to inspect the valve's diaphragm. The diaphragm should remain open under the 10 inches of vacuum for a minimum of 20 seconds. If the diaphragm does not open, of if the needle on the hand-pump gradually drops before 20 seconds have expired, the EGR valve leaks and must be
Where is the egr valve located on a 1993 dodge stealth rt 3.0 DOHC?
The EGR valve on mine is behing the intake manifold. Comes off the back exhaust manifold. Right behind the inake inlet.
